Question: A large beam is simply supported ( pin - roller ) over a 1 5 0 f t span. The beam is loaded with a

A large beam is simply supported

(

-

roller

)

over a

150 f t

span. The beam is loaded with a uniform load of

20 k i \frac{p}{f} t .

First draw the bending moment and shear force diagram. Calculate the and label on the diagrams the maximum shear and maximum moment. Then calculate and label the shear and moment located

116

inches from the center of the support. Also calculate the ratio of the bending moment to the shear force at this location,

116

inches from the center of the support.

A large beam is simply supported ( pin - roller )

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Civil Engineering Questions!

A beam of wide-flange cross section (see figure) has the following dimensions: b = 5 in., t = 0.5 in., h = 12 in., and h1 = 10.5 in. The beam is simply supported with span length L = 10 ft and...

Calculate the deflection of a simply supported beam with a span of 8 meters under a uniform load of 5 kN / m . Determine the factor of safety for a slope with an angle of 3 0 degrees, cohesion of 1 0...

Determine the end support reactions for beam B 2 . Represent this beam as simply supported ( pin support on one end and roller support on the other ) . Using a straight edge, draw a FBD to scale and...

Question 1 : Beam ABCD is loaded as shown below. The beam is simply supported ( pin support at A and roller at B ) . a ) Determine the support reactions at A and B . b ) Construct the shear force and...

1. A metal beam of span L=3ft is simply supported at points A and B (see Fig. (a)). The uniform load on the beam (including its own weight) is q-160 lb/in. The cross section of the beam is...

1 . A Douglas Fir - Larch No . 1 rectangular wood beam with a span of 1 4 feet is simply supported at both ends. The beam is subjected to a uniform load of 4 5 0 lb / ft ( including the self - weight...

A solid cylindrical shaft is subjected to a bending moment of 5 0 0 Nm and a torque of 3 0 0 Nm . Determine the principal stresses and the maximum shear stress at a point on the surface of the shaft....

Consider an oligopolistic market with N = 3 identical firms, all three making a homogeneous product. The inverse demand for this product is p = 200-3Q where Q is the market quantity. The marginal...

what is electricity

From 1 9 2 6 to 2 0 1 9 , the large - company stocks earned, on average, an annual return that is _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ lower than that earned by the small - company stocks. Multiple Choice...

Sale of equipment Equipment was acquired at the beginning of the year at a cost of $34,500. The equipment was depreciated using the double-declining-balance method based on an estimated useful life...