Question: A motor shaft is driven with a ( 1 0 - mathrm { kW } ) motor at 5 0 0 rpm

A motor shaft is driven with a \(10-\mathrm{kW}\) motor at 500 rpm . Every 0.5 meters the shaft drives a 2- kW load. Assume \( G=100\mathrm{GPa}\) and that the maximum allowable shear stress is 50 MPa . If the shaft is solid, what diameter is required between each load? For this sizing, plot the twist rate and maximum shear stress in the shaft.
A motor shaft is driven with a \ ( 1 0 - \ mathrm

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Mechanical Engineering Questions!

Q:

ANSWER ALL QUESTIONS. WILL GIVE A GOOD RATING FOR A CORRECT ANSWERS ONLY 2-35E A spring whose spring constant is 200 lbf/in has an initial force of 100 lbf acting on it. Determine the work, in Btu,...

Q:

ANSWER ALL QUESTIONS. BE SURE TO ANSWER 2 -1 C What is the difference between the macroscopic and microscopic forms of energy? 2-2C What is total energy? Identify the different forms of energy that...

Q:

Design a spur speed reducer that will take power from the shaft of an electric motor rotating at 1200 rpm and deliver it to a machine that is to operate at approximately at 155 rpm. You are proposing...

Q:

1.Sketch a line diagram to the types of business organisation on the basis of ownership 2.What do you understand by joint sector companies? Mention the diagrams for the formation of joint sector...

Q:

An electric motor draws a current of I= 10 amp with a voltage of 110 V, as shown in the figure below, where hA = 3.5 W/K. The output shaft develops a torque of = 9.727 N-m and a rotational speed of...

Q:

1.Sketch a line diagram to the types of business organisation on the basis of ownership 2.What do you understand by joint sector companies? Mention the diagrams for the formation of joint sector...

Q:

What is "profiling"? What are the advantages and disadvantages of its use? How does the use of profiling relate to ethics? 20) A moral and ethical issue raised by the information age is the...

Q:

What is "profiling"? What are the advantages and disadvantages of its use? How does the use of profiling relate to ethics? 20) A moral and ethical issue raised by the information age is the...

Q:

3. The sketch shows an exploded drawing of a pump driven by a 1.5-kW, 1800-rpm motor integrally attached to a 4:1 ratio gear reducer. Reducer shaft C is connected directly to pump shaft C' through a...

Q:

The Gearbox shown in Figure is connected to a Motor M rotating at 3200 rpm. The system is used to transmit power to two mechanical loads: Load 1 requiring (10-0.6*(L+S)) kW connected to the output...

Q:

Needed Information Molar mass of Ba(OH)2 = 171.35 g/mol If 50.0 grams of Ba(OH), is dissolved in 750 g calculate %(m/m) Report answer to 3 significant figures (Did you pay very close attention to...

Q:

A PCM waveform has the two states + 1 and 0. Suppose the transition matrix is The initial value of the waveform is determined by the flip of a coin, with the outcome of a head corresponding to + 1...

Q:

What is homemade leverage?

Q:

Relevant costs Assume that you are about to graduate from your university and are deciding whether to apply for graduate school or enter the job market. To help make the decision, you have gathered...