A pivot in a linkage includes the pin in the figure whose dimension $a+-t_a$ is to be

established. The thickness of the link clevis is $1\mathrm{.}625+-0\mathrm{.}005$ in$.$ The designer has

concluded that a gap of between $0\mathrm{.}01$ and $0\mathrm{.}06$ inch will satisfactorily sustain

the function of the linkage pivot.

part $($b$)$ Determine the gap upper tolerance, to $3$ decimal places. Note upper

tolerance is defined by the variation between the maximum and nominal size.

$-----------------------------$

$1\mathrm{.}720$ and $0\mathrm{.}018$ ARE WRONG ANSWERS only Post if youre sure about the right answer