Question: A rotary actuator has the following physical data: Outer radius of rotor RR = 0.80 in Outer radius of vane Ry = 1.7 in

A rotary actuator has the following physical data: Outer radius of rotor

A rotary actuator has the following physical data: Outer radius of rotor RR = 0.80 in Outer radius of vane Ry = 1.7 in Width of vane L = 0.5 in If the torque load is T = 900 in-lb, what pressure p must be developed to overcome the load? (Hint: the volumetric displacement Vp = TX (R - R) L, and the torque VD T=px :) (2x) O 9 psi 1250 psi 1600 psi 900 psi 3.534 psi

Step by Step Solution

★★★★★

3.43 Rating (156 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

The detailed answer for the above question is provided ... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Mechanical Engineering Questions!

Calculate the minimum kinetic energy that the carriage should possess at the top of the 15M diameter loop and the minimum height of release(h) of a roller coaster carriage to complete the loop.Mass...

Fill in the blanks in the following table: Units of Labor 1 2 3 4 5 Total Product 40 138 210 Average Product 40 46 44 35 29 Marginal Product 40 48 90 24 186 -27

The use of information systems saves workers and businesses countless hours of tedious labor. Still, users of information systems often become frustrated with the system's inability to grasp simple...

2-55 Consider the following information about March 1992 nonfarm employment (in thousands of workers) in the United States, including Puerto Rico and the Virgin Islands: Alabama Alaska Arizona...

Two major themes from the introduction to module 4 are "Project Management" and "Managing Risk." Discuss, in depth, your analysis of the company's actions in relation to the concepts of these two...

Uhapter iz Rotational Motion II: Moment of Inertia (Composite Systems) In the previous lab we examined the concepts mo tion rotating about a xed axis of a platform which we approximated as a rod as...

\fwhere Mis the mass and Rais the radius of the disk. The rotational inertia of the ring about an axis through its Of and parallel to the symmetry axis of the ring is IRoy = 42 M(RY + R/) (3) where...

\fll'o find the rotational inertia of the ring and disk experimentally, a known torque is applie d to the - ring and disk, and the resulting angular acceleration, I1, is measured. See Fig. 3. r=Itt...

From the standpoint of making a good business decision, how useful is the objective of punishment in pursuing a fraud investigation?

Chaiken entered into separate but nearly identical agreements with Strazella and Spitzer to operate a barber shop. Under the terms of the partnership agreements, Chaiken would provide barber chairs,...

Which of the following statements expresses the thought most clearly? According to the policy, which is new, at least 2 0 percent of annual operating revenue will be set aside to fund capital...

A particle is scattered by a potential at sufficiently low energy so that the phase shifts & =() for 1>1. Assume rotational symmetry. (a) Show that the differential scattering cross section has the...

Q: What is horizontal line test? Q2: write down application of homogenous differential equations

Find the physical dimensions of wave function (r) of a particle moving in three dimensional spaces.

a) May the resale of treasury stock (repurchased stock) result in a gain if the company is able to sell its treasury stock for more than what they had paid to repurchase the stock?

A segment of a generator shaft is subjected to a torque T and an axial force P, as shown in the figure. The shaft is hollow (outer diameter d2 = 300 mm and inner diameter d1 = 250 mm) and delivers...

A rectangular beam with notches and a hole (see figure) has dimensions h = 5.5in., h1 = 5in., and width b = 1.6in. The beam is subjected to a bending moment M = 130k-in., and the maximum allowable...

A small dam of height h = 2.0 m is constructed of vertical wood beams AB of thickness t = 120mm, as shown in the figure. Consider the beams to be simply supported at the top and bottom. Determine the...

Consider the construction of a research building for Eli Lilly & Co., a pharmaceutical company, a few years ago. This 550,000 ft2, 4-story (in 3 wings), $135 million building was planned to be...

Use the following activities and their three duration estimates (in days) to do the following: a. Determine the expected duration of the project. b. Calculate the probability' that the project will...

A project manager has compiled a list of major activities that will be required to install a computer information system in her company. The list includes 3-point estimates of durations (optimistic,...