Question: A scraper is loading and hauling material with a 1 . 2 0 swell factor a distance of 7 stations to a waste site. The

A scraper is loading and hauling material with a 1.20 swell factor a distance of 7 stations to a waste site. The scraper's heaped capacity is 24 cubic yards. The scraper's estimated production rate is _____ BCY per hour. Assume a 4.0 mph average speed, a 52-minute hour, and a 1.6 minute load, turn, and spread time.

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Civil Engineering Questions!

Q:

2. Calculate the annual energy recovery from MSW. 3. Simulate the entire scenario in SAM Software (You can use HOMMMER if you have a relative experience). Make sure in your simulation the lectrcity...

Q:

Image transcription text Module 5 Discussion A' Instructions: This discussion will be completed in two parts, and will give you an opportunity to reect upon this week's content and to interact with...

Q:

scraper and per- 6. A contractor has been awarded a contract for the construction of a regional shopping center. The project plans and specifications require the construction of a 3-foot compacted...

Q:

Find attached Ingredients: Water, MCC, Salt, Nicotine, pH regulator, sweeteners and flavours I am wondering why the decision to go with LYFT. I understand migrating to LYFT would be easier from sells...

Q:

Paul has asked you to answer the following questions and provided you with information about the hauling equipment (coefficients of traction and travel time charts): 6) b) C) d) e) 1) What is the...

Q:

2. (a)30pts. Determine the hourly crew labor costs given the following information: $32.35/hr $22.85/hr $30.35/hr $30.85/hr $25.75/hr Base salary- Foreman Laborer Scraper Operator Dozer Operator...

Q:

A contractor is planning to use single pusher scrapers to move 90,000 cubic yards of soil, and the expected production of a single pusher scraper assuming adequate pusher support is 230cy/hr. It has...

Q:

Please answer all parts. Thanks! A contractor has purchased a single-engine scraper for $850,000 and expects to use it about 1,500 hours per year. The contractor expects to sell the scraper after...

Q:

A project requires a contractor to excavate 28,000 bank CY dry earth, haul it away to a borrow area located 3 miles away. The contractor has 4 weeks to complete the work. The contractor doing the...

Q:

Develop a computer program to calculate the number of pushers required to service a specified scraper fleet. Input should include scraper cycle time, method of push loading, and whether single or...

Q:

The incircle of AABC touches BC at D. The difference between BD and CD (R is circumradius) is (A) 4R sin sin ",| BC 2. (B) 4R cos 4sin | B-C COS (C) 6 c| b-e (D) 2

Q:

How many years does it take to save $4,341 if you start with $810 and earn a 9% annual interest rate?

Q:

a firm with a flexible short term financial policy will: maintain low balance in account rec, only have minimal accounts

Q:

uestion Ot yet swered 3 arked out of 2 Flag question Use Table 1 to answer this question. XYZ Corporation has provided the following data from its activity-based costing system (Table 1). The company...