A temperature transmitter (0-5 Volt) with a measurement range from 0-200 C is connected to port A0 on Arduino Uno.Arduino is also connected to a PC via a serial port with baud rate 115200 bps. Create a code in setup () and loop () so that the signal from the temperature transmitter is read 10 times a second. For each new measurement, the converted temperature should be written to the serial port . If the temperature exceeds 150 C, a LED (connected to D13) should light up and this should not be turned off before the temperature falls below 145 C.

On the screen, the following curves are displayed:

0 C, 145 C, 150 C, 200 C and current temperature.

A)Explain how you will control that the program reads and writes the temperature 10 times per second. You should not write code for this just explain!!