Question: a) In order to light up the LED, what should Pin 1 and Point B be connected to? Ans: Pin 1 connected to (5V /


a) In order to light up the LED, what should Pin 1 and Point B be connected to?
Ans: Pin 1 connected to (5V / GND), Point B connected to (5V / GND)
b)What is the currency shown on the multimeter? Is the current flowing out from Pin 2 or flowing into Pin 2?
c) Replace the led and resistor with a multi-meter and measure the current again. Is
the current flowing out from Pin 2 or flowing into Pin 2.
The above method will allow you to know the maximum current sink by the IC.
Vc |14 13 12 11 10 9 |8 1 3 4 6 7 GND Make the following connections 74LS04 Pin 1 Point B 3302 Pin 2
Step by Step Solution
3.45 Rating (168 Votes )
There are 3 Steps involved in it
a Connect point B to 5V supply and conn... View full answer
Get step-by-step solutions from verified subject matter experts
