Question: Applied Hydraulics # 5 . 1 . 5 . Determine the power requirement ( k W ) for a motor that is needed to drive

Applied Hydraulics #5.1.5.
Determine the power requirement (kW) for a motor that is needed to drive the pump installed in a pipeline that moves 2.05m3s from reservoir A to reservoir B. The 100-m-long, 80-cm-diameter pipe is made of rough concrete. The water surface of reservoir B is 20m higher than the water surface of reservoir A. The pump efficiency is 80% and the motor efficiency is 74%.
Applied Hydraulics # 5 . 1 . 5 . Determine the

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock

Applied Hydraulics Question ID 26886759 Given Data Flow rate Q 205 textm3texts Pipe length L 100 tex... View full answer

blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Civil Engineering Questions!

Q:

Hello, you already did chapter 1 and 2 of my MASTERS Thesis already for me. (See attached) So normally you know masters thesis consist of 5 chapters right ??..... But in this case my thesis will be 4...

Q:

5-180 Determine the power input for a compressor that compresses helium from 150 kPa and 20C to 400 kPa and 200C. Helium enters this compressor through a 0.1-m2 pipe at a velocity of 15 m/s. 5-181...

Q:

ATTEMPT ALL QUESTIONS. BE SURE TO ANSWER A body with mass m = 1 2 kg is attached to the end of a spring that is stretched 2 m by a force of 100 N. Furthermore, there is also attached a dashpot4 that...

Q:

Please help me .. am stuck... please address all questions clearly:- The power rating of a motor can be modified to account for different ambient temperature, according to the following table:...

Q:

ANSWER ALL QUESTIONS. BE SURE TO ANSWER 2 -1 C What is the difference between the macroscopic and microscopic forms of energy? 2-2C What is total energy? Identify the different forms of energy that...

Q:

This text was adapted by The Saylor Foundation under a Creative Commons Attribution-NonCommercial-ShareAlike 3.0 License without attribution as requested by the work's original creator or licensee. 1...

Q:

What is the difference between a reversible and irreversible gas expansion? [26] How does a car battery store energy? [27] What are the common muzzle exit velocities for ammunition in normal ries?...

Q:

ANSWER ALL QUESTIONS. WILL GIVE A GOOD RATING FOR A CORRECT ANSWERS ONLY 2-35E A spring whose spring constant is 200 lbf/in has an initial force of 100 lbf acting on it. Determine the work, in Btu,...

Q:

1 WILMINGTON UNIVERSITY LIBRARY Business Continuity Plan (BCP) and Disaster Recovery Plan (DRP) 2 WILMU LIBRARY SERVICES 20,000 student population served 13 physical locations of access to university...

Q:

Question 1 1.1 What is a variable speed drive (VSD), and how can it be used to reduce energy wastage in industrial applications? What systems can make use of VSDs? (Max. 100 words) Start writing...

Q:

A steel ring with a 2.5000-in. inside diameter at 20.0C is to be warmed and slipped over a brass shaft with a 2.5020-in. outside diameter at 20.0C. (a) To what temperature should the ring be warmed?...

Q:

Austin Corporation is proposing the establishment of a pension plan that will cover only employees with salaries in excess of $150,000. No other employees are covered under comparable qualified...

Q:

Jiky Le . an employee of Sweet Shoppe Industries, rectives a bonus of $ 1 , 9 0 0 for her sheller mork. Her boss warts Wicly to receive 6 3 . 9 0 0 on the check. She contributes 3 percent of her pey...

Q:

Turnbull Co. is considering a project that requires an initial investment of $1,708,000. The firm will raise the $1,708,000 in capital by issuing $750,000 of debt at a before-tax cost of 8.7%,...