As an engineer, you are requested to develop an Arduino project to control a fan based on the room temperature, attached to a DC Motor, an L298H Bridge and an LM35 temperature sensor. The project should switch ON the fan and LED when the temperature of the room exceeds 25C. Else, the fan and LED will both be off. Write an Arduino script that executes the conditions of the above brief. Your code should not exceed the below 2 pages. Note: To convert the analog signal from LM35 sensor to C use the following equation Temperature (C) = (5.0-reading 100.0)/ 1023.0 9v L2964 H-Bridge 42 } O UNO ***** ***** *** ******** ***** fritzing Write the Arduino Code for Q3 Below.