Assembly Program Using Visual Studio C++. The problem Part C at the bottom. Thanks

Download the program in section 3.2 from: Open the kipirvine link below to download a zip file containing a 32-bit Visual Studio 2015 project

http://kipirvine.com/asm/gettingStartedVS2015/Project32_VS2015.zip

Do the following steps, in order:

Start Visual Studio.

To begin, open our sample Visual Studio project file by selecting File/Open/Project from the Visual Studio menu.

Navigate to your working folder where you unzipped our project file, and select the file named Project.sln.

Once the project has been opened, you will see the project name in the Solution Explorer window.

You should also see an assembly language source file in the project named AddTwo.asm

Double-click the file name to open it in the editor.

3. You should see the AddTwo assembly program in the editor window

4. Delete the two instruction there and then add your code in there:

.386

.model flat,stdcall

.stack 4096

ExitProcess proto,dwExitCode:dword

.code

main proc

;add your code here

invoke ExitProcess,0

main endp

5. After you added your code, select Build Project (this will assemble and link your program) from the Build menu. Make sure there are no errors and the project was built successfully

C. (5 points Write an assembly language program that does the following: Define the following value l0113Aich using the appropriate identifier. Reorder its byte values in little-endian order using the mov instruction and the values' ofset. Store the values in four 8-bit registers, al, bl. cl, dl. o submit the following: Lastname 3.asm