Assignment Control Charts for Attributes Complete problem #6 Pbar = UCL = LCL = List the subgroup #(s) that are out of control Revised Pbar = Revised UCL = Revised LCL = Do not submit the run chart 6. Construct a plot on normal probability paper (a blank form is at the end of lesson 3) (3 marks) Measurement results of the diameter of a shaft turned on a CNC lathe Specifications: 0.7495 0.7505 1 2 3 4 5 6 7 8 9 10 1 0.7501 0.7501 0.7503 0.7501 0.7502 0.7497 0.7497 0.7500 0.7502 0.7496 2 0.7501 0.7500 0.7498 0.7502 0.7496 0.7504 0.7501 0.7502 0.7502 0.7501 3 0.7500 0.7499 0.7502 0.7503 0.7500 0.7503 0.7503 0.7500 0.7500 0.7499 4 0.7500 0.7502 0.7503 0.7501 0.7498 0.7500 0.7502 0.7503 0.7498 0.7501 5 0.7501 0.7499 0.7501 0.7501 0.7499 0.7500 0.7498 0.7501 0.7501 0.7500 Draw vertical lines on the graph to represent the LSL and USL. Draw horizontal lines to represent three standard deviations. Estimate of % nonconforming above USL = Estimate of % nonconforming below LSL = Total estimated % nonconforming beyond the specification limits = Please attach the plot with your submission