\begin{tabular}{|c|c|c|c|c|} \hline Element \& Description & 1 & 2 & 3 & 4 \\ \cline { 2 - 5 } & Remove Machined Part & Adjust for next cycle & Load wext part, start auto cycle & Inspect Machined Part \\ \hline Cycle & NT & NT & NT & NT \\ \cline { 2 - 5 } 1 & 0.32 & 1.18 & 0.23 & 0.96 \\ \hline 2 & 0.46 & 1.08 & 0.30 & 1.00 \\ \hline 3 & 0.38 & 0.88 & 0.27 & 0.89 \\ \hline 4 & 0.34 & 1.00 & 0.30 & 0.87 \\ \hline 5 & 0.36 & 1.19 & 0.25 & 0.59 \\ \hline 6 & 0.32 & 1.16 & 0.25 & 0.97 \\ \hline 7 & 0.32 & 0.96 & 0.30 & 0.81 \\ \hline 8 & 0.40 & 1.16 & 0.27 & 0.70 \\ \hline 9 & 0.36 & 1.04 & 0.33 & 0.97 \\ \hline 10 & 0.36 & 1.29 & 0.30 & 0.76 \\ \hline Summary & & & & \\ \hline Total NT & 3.62 & 10.94 & 2.80 & 8.52 \\ \cline { 2 - 5 } & 10.00 & 10.00 & 10.00 & 10.00 \\ \hline Number of Cycles & 0.36 & 1.09 & 0.28 & 0.85 \\ \hline Average NT & 10.00 & 12.00 & 12.00 & 12.00 \\ \cline { 2 - 5 } \% Allowance & 1.23 & 0.31 & 0.95 \\ \cline { 2 - 5 } & 0.40 & 1.36 & \\ \hline \end{tabular} to run. Determine the value for " N " as well as the unit cost per part for the two assignment alternatives. You will not enter your answers in this section, but in the questions that follow. Enter a value calculated for " N