C- CURRENTS IN SERIES 13. Now remove the wires between S5 and S6, and between S6 and S7. Connect S5 and S6 directly to S8 (see Fig. 9). To measure the current, you will connect the Current Sensor in the circuit at different positions. For this you will have to remove the connecting wires, and replace them with the current sensor. 14. Connect the Current Sensor to Capstone Software. 15. First, remove the wire connecting the switch SW2 to S4, and attach the Current Sensor in its place. Make sure that the polarity of the sensor is correct. Press Record in Capstone, press the switch for a few seconds, release the switch, stop recording in Capstone. Note the current value I0 in Table 3. Remember to start with a high current range, and reduce the max range as needed. 16. Now replace the wire between SW2 and S4. Remove the wire between S5 and S8 and replace it with the current Sensor. This is the one shown is Fig, 9. Press Record in Capstone, press the switch for a few seconds, release the switch, stop recording in Capstone. Note the current value I1 in Table 3. 17. Replace the wire