Question: Cascade amplifier is used because a . High Voltage gain b . High output impedance c . High input impedance

Cascade amplifier is used because
a. High Voltage gain
b. High output impedance
c. High input impedance

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

iCMOS amplifier two stage Objective: The objective of this project is to design, build, simulate, and write a technical report on directly coupled two-stage amplifier. The amplifier should have a...

Q:

QUESTION 1 (40 marks) The most important consideration in Power Amplifiers is the collector terminal efficiency of the amplifying component. In practice, among all Amplifier classes, the class A...

Q:

Q.1. (a) An op-amp has CMRR = 100dB, differential gain Ap = 5 and common mode voltage applied to it is 3 mV. Find the value of common mode output voltage. (b) An op-amp has differential gain AD =...

Q:

Collige of Engineering Technology and Archisecture UNIVERSITY OF HARTFORD Department of Electrical Computer Enginering ECT 232 N2, 13) very high voltage gain C) very high output impedance D) very low...

Q:

Hello, through the text of the theory and through the procedure that I have taken and the results that you have recorded in the table, so how do I please help me in giving an answer to the discussion...

Q:

MATLAB page 188 MATLAB from page 173: Only Question 2 please Question 1. [10 points] This BJT broadband amplifier is going to be converted into a narrow band tuned amplifier. The BJT is a 2N2904 with...

Q:

Please answer ASAP and comment again if you are still working on the problem. Please box final answers and answer all portions of the question correctly and you will be given thumbs up. See attached...

Q:

Please answer all question Subject: IoT A proposed IoT room occupancy monitoring system that is designed to detect the temperature and light is represented with the block diagram in Figure 4. The...

Q:

1. An integrated circuit (IC) op-amp has (a) two inputs and two outputs (c) two inputs and one output 2. Which of the following characteristics does not necessarily apply to an op-amp? (a) High gain...

Q:

Q3 (Total 40 Marks) A vibration sensor is used to measure the vibrations caused by a car engine. It is mounted into a Wheatstone bridge as shown in Figure 3. The vibration sensor has a reference...

Q:

16. KFE3AISI3010(OH)2 + Cu + O2 + H2S ---> KAISi3Og + CuFeS2 + H2O 17. SiO2 + CaC2 ---> Si + CaO + CO2 18. NH3(g) + O2(g) ---> NO2(g) + H2O(g) 19. MgNH4PO4 20. Balance: PC15 + H2O ---> H3PO4 + HCl...

Q:

1. There are 4 (four) global operating strategies. Explain the four strategies and give examples. 2. Explain the challenges that must be faced by the company in facing productivity.

Q:

A transaction has been recorded in the T - accounts of Vernon Company as follows: LandDebitCredit 1 0 , 0 0 0 CashDebitCredit 1 0 , 0 0 0 Which of the following reflects how this event affects the...

Q:

1 . Given the following hydraulic components. - hydraulic tank. - pilot operated relief valve. - 4 / 2 manually operated DCV . - check valve. - double acting hydraulic cylinder. - pressure switch. -...