Circuits

INTRODUCTION: An example of a simple resistor circuit is displayed below. V1 R1 In such circuits, vi is a voltage source (V) and Ri is a resistor (). The current in these circuits may be calculated using Ohm's law: The power dissipated across the resistor is In the above equations, I is the current in amps (A), V is the voltage in volts (V), R is the resistance in ohms (), and P is the power in Watts (W) An input data file called circuits contains voltage and resistance information for a set of simple resistor circuits. The first record line of the input file is the control number, which defines the number of circuits to be read into the program. Each succeeding record line has two columns, where the first column is the voltage and the second column is the resistance. The input file is comma delimited. ASSIGNMENT: Write a C program that will read the required values from the input file. Using the voltage and resistance, compute the current in each circuit and the power dissipated by the resistor in each circuit. Your program will produce a report in tabular format. Print the table to the computer screen and to an output file called levels. Once the program is working, modify the program to account for any current that is greater than 0.I amp