NO C++......PLEASE Write a C program ANSI that will read the required values from the input file NO other format will be accepted INTRODUCTION An example of a simple resistor circuit is displayed below V1 R1 In such circuits, V1 is a voltage source (V) and Rl is a resistor (2). The current in these circuits may be calculated using Ohm's law: The power dissipated across the resistor is in the above equations, 1 is the current in amps (A), Vis the voltage in volts (V), R is the resistance in ohms (), and P is the power in Watts (W) An input data file called circuits contains voltage and resistance information for a set of simple resistor circuits. The first record line of the input file is the control number, which defines the number of circuits to be read into the program. Each succeeding record line has two columns, where the first column is the voltage and the second column is the resistance. The input file is comma delimited. ASSIGNMENT Write a C program that will read the required values from the input file. Using the voltage and resistance, compute the current in each circuit and the power dissipated by the resistor in each circuit. Your program will produce a report in tabular format. Print the table to the computer screen and to an output file called levels. Once the program is working, modify the program to account for any current that is greater than 0.1 amp. Instead of printing the nomal column items, for any circuit with curent greater than 0.1 amp, print the voltage, the resistance, and then print a message that the current may be fatal. The output format is shown on page 2 Use the "Code Sections-c" template to write your code. OUTPUT FORMAT: CIRCUIT AMPERAGE AND POWER Voltage Resistance Current Power ohms xxxX x.xx *Current may be fatal * FILE PATHS: Before submitting your Csource program, make sure that you set your input and output file paths to U ENGR 200 Input data 13 4 B0,5100 192,1800 192,2100 810,3000 190,2500 380,100 400,4250 4 00,2500 240,3000 240,2500 150,1600 110,9200 910,750