complete the chart below based on the following specifications. (Make sure you use VLSM) a. You are assigned the 192.168.1.128/25 network b. The Student Lab has 50 hosts c. The Teacher Lab has 10 hosts d. The network connecting the two routers is a peer to peer network (2 hosts) Location Network Address Subnet Mask CIDR Broadcast Address Student Lab 192.168.1.128 Teacher Lab 192.168.1.192 Peer to Peer Network 192.168.1.208 2. Complete the following chart. Device/Port IP Address Subnet Mask CIDR Student Router (Wan Link- S0/0/0) Assign the first usable address in the subnet Router 2 ( Wan Link- S0/0/0) Assign the last usable address in the subnet Student Router Lan Addressing (G0/0/0) Assign the first usable address in the subnet Teacher Router Lan Addressing (G0/0/0) Assign the first usable address in the subnet PC Connected to (Student Lab Network) assign the last Usable IP Address in this network PC connected to Teacher Lab Network Assign the last usable IP Address in this network 3. Download Advance_Routing.PKT from the LMS 4. Correctly configure both routers and PC's- Make sure you do the following a. Use the config portion of the Student Router i. Assign the S0/0/0 IP Address ii. Assign the G0/0/0 IP Address b. Use the config portion of the Teacher Router i. Assign the S0/0/0 IP Address ii. Assign the G0/0/0 IP Address c. Statically configure the IP address of the Student Lab Computer d. Statically configure the IP address of the Teacher Lab Computer e. Note- You should not touch the switches or the wires. f. In addition two Static Routes have been added for you they are as follows 5. If everything is configure correctly Student Lab Computer should be able to ping Teacher Lab Computer. ping and attach a screenshot 6. If the ping fails, troubleshoot your network and attach a screenshot once Student Lab Computer can successfully piing Teacher Lab Computer.