Question: At the inlet of an adiabatic duct with constant cross-sectional area, the pressure, the temperature and the velocity are 0.122 MPa, 16 C and

At the inlet of an adiabatic duct with constant cross-sectional area, the

At the inlet of an adiabatic duct with constant cross-sectional area, the pressure, the temperature and the velocity are 0.122 MPa, 16 C and 127 m/s, respectively. The length and diameter of the duct are 6.5 m and 50 mm, respectively. If the average friction factor is 2.8 x 10-3, determine the Mach number, temperature and pressure at the exit of the duct. What is the maximum mass flow rate in this system.

Step by Step Solution

★★★★★

3.47 Rating (147 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

To solve this problem we can use the conservation equations for mass momentum and energy along with the isentropic flow relations Lets go step by step Given Inlet conditions Pressure at the inlet P 01... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Accounting Questions!

A MPV has seven passenger seats one in the front, and three in each of the other two rows. a. In how many ways can all 8 seats be filled from a party of 12 people, assuming that they can all drive?...

Calculate the mass flow rate of the steam that enters an adiabatic duct with a velocity of 10 m/s, at a pressure of 1.5 bar and a temperature of 400C. The duct has a diameter of 0.16 m at the inlet...

Questions to be solved: 1- Assuming the role of Sarah McIvor, CA, prepare a two page memorandum that analyzes the financial conditions of Gemini Electronics and makes recommendations relating to the...

In problem 15-3-14 [BNF] determine the diffuser efficiency if the shock is (a) at the inlet and (b) at the exit (%). Problem 15-3-14 Air approaches a diffuser with a pressure of 20 kPa at a Mach...

Air flows steadily through a long insulated duct with a constant cross sectional area of 100 cm2. At the inlet, the conditions are 300 kPa, 300 K and 10 m/s. At the exit, the pressure drops to 50 kPa...

In the circuit shown, Vo = 2 V. Find Is. 12 2 8 10 3

Piniella Company has the following data for the weekly payroll ending January 31. Employees are paid 112 times the regular hourly rate for all hours worked in excess of 40 hours per week. FICA taxes...

Reconsider Prob. 589. Using EES (or other) software, investigate the effect of the inlet temperature of cooling water on the mass flow rate of water. Let the inlet temperature vary from 10 to 40C,...

Air is used as the working fluid in a simple ideal Brayton cycle that has a pressure ratio of 12, a compressor inlet temperature of 310 K, and a turbine inlet temperature of 900 K. Determine The...

Reconsider Prob. 855. Using EES (or other) software, solve the problem and in addition determine the actual heat transfer, if any, and its direction, the minimum power input (the reversible power),...

Air enters the compressor of an ideal gas refrigeration cycle at 40F and 10 psia and the turbine at 120F and 30 psia. The mass flow rate of air through the cycle is 0.5 lbm/s. Determine (a) The rate...

Consider the following exponential function. State the asymptote, and find 4 points on the graph. For the 4 points, the r-coordinate is given. Fill in the y-coordinate. f(x)=3* asymptote: first...

What recognition criteria are applied to assets and liabilities acquired in a business combination?

Consider a firm with an EBITDA of $ 1 6 , 8 0 0 , 0 0 0 and an EBIT of $ 1 2 , 4 0 0 , 0 0 0 . The firm finances its assets with $ 5 3 , 8 0 0 , 0 0 0 debt ( costing 7 . 9 percent all of which is tax...

Use Equation 37.5 to calculate the average energy of a conduction electron at T = 0 in terms of the Fermi energy. (27/2Tm 32 VE g(E) = (37.5) h3

Give an alternative implementation of the HeapPriorityQueues upheap method that uses recursion (and no loop).

Can the government run a deficit in the one-period model? Why or why not?

The species resulting from the addition of benzene to HF SbF 5 (Exercise 15-24) shows the following 13 C NMR absorptions: = 52.2(CH 2 ), 136.9(CH), 178.1(CH), and 186.6(CH) ppm. The signals at =...

Resistors labeled as 100 are purchased from two different vendors. The specification for this type of resistor is that its actual resistance be within 5% of its labeled resistance. In a sample of...

Jillian is thinking of a whole number that is greater than 21. What numbers, if any, make the inequality n>21 true for n=0,1,2,3,4,dots ?

ATTEMPT ALL QUESTIONS. BE SURE TO ANSWER A body with mass m = 1 2 kg is attached to the end of a spring that is stretched 2 m by a force of 100 N. Furthermore, there is also attached a dashpot4 that...

Assume that the fuel inlet temperature is 25C. # Question 1. Calculate the adiabatic flame temperature of Methane (CH4) gas with theoretical air of 85%, 100% and 400%, for an inlet air temperature of...

5-43C Consider an adiabatic turbine operating steadily. Does the work output of the turbine have to be equal to the decrease in the energy of the steam flowing through it? 5-44C Consider an air...

An irreversible elementary gas-phase reaction A+B-C is to be carried out in a steady-state Packed Bed Reactor (PBR) with countercurrent heat exchange along the length of the PBR, as illustrated in...

A well-designed convergent-divergent inlet may allow nearly isentropic operation when the flight speed is at the design Mach number. For preliminary sizing purpose, you can assume everything is ideal...

Awaroa Inlet is a tidal estuary in the Abel Tasman National Park. The inlet is on a popular walking track and can only be crossed at certain times of the day because of the tides. When the tide comes...