Create a table with the values needed to trace the part based on the drawing. Use manual compensation for a end mill of $1/4$ diameter. Table should have the following in the first row, in separate columns : $$G$-$code, X$,$ Y$,$ I, J$.$ If I or J is not used for the necessary line, leave it empty or with a $-.[11$ pt$]$ After, write the full code out as a script. Code should have the beginning and end and use a spindle speed of $1500$ RPMs and use a feed rate of $27\mathrm{.}2$ IPM.

NOTE

$(0,0)$ for part does not

exist on the physical part.

$(0,0)$ exists on construction

lines offset by $(0\mathrm{.}625,0\mathrm{.}5)$