Create your first packet as shown bel in the screenshot Where dst is the IP address of Metasploitable VMUse the method ls$($p$)$ to answer the questions belowType$\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_$SourceMACField$\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_$Sending the packet, after we create the packet p we will send it using method srp as shown below. Where iface represent the used interface $($could be acquired from ifconfig command$)$Note: you may have a permission error, in that case you need to start Scapy using Sudo Now use the show method to answer the questions below What is the type of ICMP message sent$\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_?$Now we use using Scapy to launch a simple spoofing attack on Metasplotable VM To validate the attack take we need to conduct arp $-$a command on Metasploitable Vms as shown below The table shows the IPs, and MAC addresses for the devices contacted by the targeted VM The crafted packet below could be used to spoof the IP of the sender and poison the ARP table. If the psrc is equal to the gateway IP$,$ this means all the communications from the target to the gateway would be sent to the attackers MAC That could be shown in the updated arp table as shown below.