Question: C-Spec, Inc., is attempting to determine whether an existing machine is capable of producing a part that has a key specification of 4.50 .003 inches.

  1. C-Spec, Inc., is attempting to determine whether an existing machine is capable of producing a part that has a key specification of 4.50 .003 inches. After a trial run on this machine, C-Spec has determined that the machine has a sample mean of 4.502 inches with a standard deviation of .002 inch.
    1. Calculate the process capability index for this example.
    2. Determine the probability of producing a defect.
    3. Calculate the DPMO of the process.
    4. Is the process six sigma compliant?

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related General Management Questions!

Q:

C-Spec, Inc., is attempting to determine whether an existing machine is capable of producing a part that has a key specification of 4.50 .003 inches. After a trial run on this machine, C-Spec has...

Q:

A metal fabricator produces metal rods with an outer diameter that has a 3.260 .01 inches specification. A machine operator takes several sample measurements over time and determines the sample mean...

Q:

C-Spec, Inc., is attempting to determine whether an existing machine is capable of producing a part that has a key specification of 4.50 .003 inches. After a trial run on this machine, C-Spec has...

Q:

C-Spec, Inc., is attempting to determine whether an existing machine is capable of producing a part that has a key specification of 4.550 .003 inches. After a trial run on this machine, C-Spec has...

Q:

C-Spec, Inc., is attempting to determine whether an existing machine is capable of milling an engine part that has a key specification of 40.02 inches. After a trial run on this machine, C-Spec has...

Q:

C-Spec, Inc., is attempting to determine whether an existing machine is capable of milling an engine part that has a key specification of 5 + 0.05 inches. After a trial run on this machine, C-Spec...

Q:

A metal fabricator produces connecting rods with an outer diameter that has a 1 +/- .01 inch specification. A machine operator takes several sample measurements over time and determines the sample...

Q:

Question 21 (4 points) C-Spec, Inc., is attempting to determine whether an existing machine is capable of milling an engine part that has a key specification of 4 + 0.006 inches. After a trial run on...

Q:

1) Output from a process contains 0.02 defective unit. Defective units that go undetected into final assemblies cost $25 each to replace. An inspection process, which would detect and remove all...

Q:

C-Spec, Inc., is attempting to determine whether an existing machine is capable of milling an engine part that has a key specification of 4 .003 inches. After a trial run on this machine, C-Spec has...

Q:

Modern Co., Inc., the electronics and appliance chain, reported these figures in millions of dollars: Requirements 1. Compute Moderns average collection period during 2011. 2. Is Moderns collection...

Q:

The project will be about a television sports show which needs to interact with a sports player with the football analysis for one hour. Scope:The scope of project depends on inviiting a football...

Q:

If a parent MNC backs the debt of a foreign subsidiary, the borrowing capacity of the parent might be reduced because creditors may not be willing to provide as many funds to the parent if those...

Q:

What is an example of constructive feedback? provide reference