Data Network Design

Not sure how to solve these steps!

2. Use the following class C address 210.210.210.0 with the subnet mask of 255.255.255.192 to subnet this network in a classful manner (SO ALL 4 SUBNETS WILL BE THE SAME SIZE). You will need to create four consecutive subnets, starting at 210.210.210.0 (ie. subnet 2 starts immediately after the broadcast address of subnet 1) Complete the following table for each subnet ] Subnet Number Network Address Broadcast Address Range of Hosts Addresses [2] [3] 3. Configure each router as specified below . Each router should have a name B Each router should have a password (use Picard) for Console Auxiliary Secret Telnet C Each router should have a Banner (MOTD) Message (your choice) [1] D The router interfaces that are being used should be configured with appropriate IP addresses [3] E Configure a description for Each Interface. [2] F Test your network to verify that all routers can ping one another. You will have to install RIP on each router, as follows: Configurer Tip Config-router network 210 210 210 0 Insert a screen shot of R3 pinging subnet and R2 pinging subnet