Question: Derive the expression for shear angle in orthogonal cutting in terms of rake angle and chip thickness ratio

Derive the expression for shear angle in orthogonal cutting in terms of rake angle and chip thickness ratio

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Mechanical Engineering Questions!

Q:

This is a subjective question, hence you have to write your answer in the Text-Field given below. (a) Using a neat figure show continuous with built-up edge chip formation in metal cutting. Explain...

Q:

. Figure 5 shows the slip-line field for machining using a cutting tool with restricted contact length 1. Assume that the friction coefficient at the tool rake face is . The shear yield strength of...

Q:

Q1) Determine the cutting force and feed (thrust) force for a turning operation using following parameters: Material tensile strength 250MPa, Shear strength 120 MPa, chip thickness ratio r = 0.45,...

Q:

Q1) Determine the cutting force and feed (thrust) force for a turning operation using the following parameters: Material tensile strength 250MPa, Shear strength 120 MPa, chip thickness ratio r =...

Q:

State whether or not the following statements are true for orthogonal cutting, explaining your reasons: (a) For the same shear angle, there are two rake angles that give the same cutting ratio, (b)...

Q:

The following measured data were taken from an orthogonal test cutting AISI 1015 steel using a tungsten carbide tool: Cutting speed .............500 ft/min Feed........................ 0.010 in....

Q:

#2. (20 marks). The shear strength of a certain work material = 50,000 lb./in. An Orthogonal utting operation for the first batch of materials is performed using a tool with rake angle = 20 at...

Q:

Shear strength: The cutting force and thrust force have been measured in an orthogonal cutting operation to be 301 lb and 291 lb, respectively. The rake angle = 12, width of cut = 0.400 in, chip...

Q:

The following data are available from orthogonal cutting experiments. The depth of cut (feed) to = 0.13 mm, width of cut b 2.5 mm, rake angle a = - 5, and cutting speed V = 2 m/s. Chip thickness, te...

Q:

4. A plane-strain machining operation is modeled as a 2-dimensional orthogonal cutting process. Two different cutting conditions are shown in Figure 1 and Figure 2 in terms of the undeformed and...

Q:

The year is within one certain year. John and Cindy are 70 and 56, respectively. They file a joint return. They have itemized deductions totaling $32,000.00. Their sources of income and deductions...

Q:

A ball of mass M rests between the grooves A and B of the incline and against a vertical wall at C. If all three surfaces of contact are smooth, determine the reactions of the surfaces on the ball....

Q:

Which of the following statements are failse? 1 . 2 . 3 . 4 . Preferred shareholders typically have the right to elect corporate directors. The required return is the rate at which a stock's price is...

Q:

Your task is to forecast 12 future values of "Sweet Wine" wine. Forecast next 12 values of Sweet Wine using HW Additive (0.46,0.015, 0.56). Consider the seasonal number M = 12. Do not select "Update...