Design a Binary Counter using T Flip$-$Flops that counts $0,1,2,3,4,5,0,....$

Steps:

A$)$ Construct the State Table. Consider unused states as don$$t care conditions. The State Table should include the Present State, Next State, and Inputs to T Flip$-$Flops.

B$)$ Using K$-$maps find the simplified input equations $($combinational circuits$)$ to the T

Flip$-$Flops$$s$.$

C$)$ Using a simulator, like the Logic.ly simulator, build each of the combinational circuits of the input equations to the T Flip$-$Flops in the previous step separately. You need one logic circuit for each T flip$-$flop. At this step you do not have any T Flip$-$Flops in the logic circuits. Using the simulator to verify via experimentation that your circuits are correct.

D$)$ Draw the complete logic circuit diagram including the T Flip$-$Flops, but without the $7-$segment display.

E$)$ Using simulate and verify the circuit works. Use the $7-$segment display to

display the output as a decimal digit, i$.$e$.0,1,2,3,4,5,0,....$

Please provide the following. Read each carefully.

$1)$ The State Table

$2)$ The K$-$maps with the SIMPLIFIED logic circuits

$3)$ A screenshot from the simulator that shows the circuits from Step C$)$ above.

$4)$ The complete logic circuit diagram drawn on paper.

$5)$ A screenshot from the simulator that contains the complete circuit implementation including the $7-$segment display.

$6)$ Write the output sequence of the $7-$segment display you observe.