Design a sequential logic circuit (using Flip-flops and other logic gates) that will act as a dice, i.e. a 3-bit, 1 to 6 counter. The dice is controlled by two push buttons: The ROLL button After one hit, the dice starts rolling, i.e. counting The STOP button After one hit, the dice stops rolling, suspended on the last counting value. YS ROLL TA STOP Given Components 1. 1x 7400: Quad 2-input NAND 2. 2 x 7473: Dual JK Flip-Flop 3. 1 x 7447: BCD-to-7 segment decoder2202 4 1x CA 7-Segment Display 5, 2 x Push Buttons + 2 10 k pull-down resistor.