Design and Analyze an 1011 non-overlapping sequence detector based on the following state diagram: 1. What kind of circuits does the state diagram represent (Mealy or Moore)? [0.5] 2. From the state diagram derive the state table with output Z. [1] 3. Using the LogicAid, find the state equation for the JK flip-flop. [1] [Add a screen: 4. Implement the logic circuit using Logisim: [2] [Add a screen shot] - Use Tunnels for the JK and output equations. - Add a 16-bit shift register to load the test code. [choose any input seq fill the following table[0.5] Design and Analyze an 1011 non-overlapping sequence detector based on the following state diagram: 1. What kind of circuits does the state diagram represent (Mealy or Moore)? [0.5] 2. From the state diagram derive the state table with output Z. [1] 3. Using the LogicAid, find the state equation for the JK flip-flop. [1] [Add a screen: 4. Implement the logic circuit using Logisim: [2] [Add a screen shot] - Use Tunnels for the JK and output equations. - Add a 16-bit shift register to load the test code. [choose any input seq fill the following table[0.5]