Detail the proper configuration with the table that's given. the packet tracer build has been implemented i
Fantastic news! We've Found the answer you've been seeking!
Question:
Transcribed Image Text:
Addressing Table: Configure EtherChannel: Device Interface IP Address Subnet Mask Default Gateway Switch Port VLAN Create the port channels groups according to the table above. VLAN 10 192.168.10.1 255.255.255.0 N/A N/A N/A Configure each port channel interface as trunk. Main VLAN 20 192.168.20.1 255.255.255.0 N/A N/A N/A Assign Natvie VLAN 99 to each trunk VLAN 88 192.168.88.1 255.255.255.0 N/A N/A N/A West VLAN 88 192.168.88.2 255.255.255.0 192.168.88.1 N/A N/A South VLAN 88 192.168.88.3 255.255.255.0 192.168.88.1 N/A N/A Note: on switch Main, you have to configure the trunk encapsulation before you can set the port channel interface as trunk. To configure the trunk encapsulation, type the command: Main (config-if)# switchport trunk encapsulation dot1q Configure Inter-VLAN Routing: Lab1 NIC Lab2 NIC 192.168.10.50 255.255.255.0 192.168.10.51 255.255.255.0 192.168.10.1 West Fa0/1 10 192.168.10.1 Office 1 NIC 192.168.20.50 255.255.255.0 Server NIC 192.168.20.5 255.255.255.0 192.168.20.1 192.168.20.1 South Fa0/1 West Fa0/11 South Fa0/11 10 Enable IPv4 routing 20 Configure all SVI interfaces on Main 20 Configure the root bridge for VLAN 10: Office2 NIC 192.168.20.51 255.255.255.0 192.168.20.1 South Fa0/12 20 By default, West will be selected as the root bridge. To balance the load, configure Main to be the root bridge for VLAN 10. (Refer to PT 6.2.4) Scenario: VLANs and EtherChannel need to be implemented in your network. Routing between the VLANS will be supported by the layer 3 switch Main. Once the EtherChannels are created, the root bridge for VLAN 10 will be changed to Main. Instructions: Configure IP addressing for all end devices and access layer switches (West and South) according to the Addressing Table above. VLAN ID Name Assigned Ports 10 Students Fa0/1 - Fa0/10 20 Staff Fa0/11 - Fa0/20 88 Management Configure VLANs: In all switches, create the VLANs according to the table above. In switches West and South, configure ports Fa0/1 - Fa0/20 as access ports and assign them to each VLAN according to the table above. (VLAN 88 has no ports assigned). Channel Group Ports Protocol Main: GO/1, G0/2 1 West: G0/1, G0/2 PAgP Main: Fa0/21, Fa0/22 2 LACP South: Fa0/21, Fa0/22 West: Fa0/23, Fa0/24 3 PAgP South: Fa0/23, Fa0/24 When the network is fully configured, all devices should be able to ping each other. West Main South Lab1 Office1 Lab2 Server Office2 VLAN 10 VLAN 20 VLAN 10 VLAN 20 Addressing Table: Configure EtherChannel: Device Interface IP Address Subnet Mask Default Gateway Switch Port VLAN Create the port channels groups according to the table above. VLAN 10 192.168.10.1 255.255.255.0 N/A N/A N/A Configure each port channel interface as trunk. Main VLAN 20 192.168.20.1 255.255.255.0 N/A N/A N/A Assign Natvie VLAN 99 to each trunk VLAN 88 192.168.88.1 255.255.255.0 N/A N/A N/A West VLAN 88 192.168.88.2 255.255.255.0 192.168.88.1 N/A N/A South VLAN 88 192.168.88.3 255.255.255.0 192.168.88.1 N/A N/A Note: on switch Main, you have to configure the trunk encapsulation before you can set the port channel interface as trunk. To configure the trunk encapsulation, type the command: Main (config-if)# switchport trunk encapsulation dot1q Configure Inter-VLAN Routing: Lab1 NIC Lab2 NIC 192.168.10.50 255.255.255.0 192.168.10.51 255.255.255.0 192.168.10.1 West Fa0/1 10 192.168.10.1 Office 1 NIC 192.168.20.50 255.255.255.0 Server NIC 192.168.20.5 255.255.255.0 192.168.20.1 192.168.20.1 South Fa0/1 West Fa0/11 South Fa0/11 10 Enable IPv4 routing 20 Configure all SVI interfaces on Main 20 Configure the root bridge for VLAN 10: Office2 NIC 192.168.20.51 255.255.255.0 192.168.20.1 South Fa0/12 20 By default, West will be selected as the root bridge. To balance the load, configure Main to be the root bridge for VLAN 10. (Refer to PT 6.2.4) Scenario: VLANs and EtherChannel need to be implemented in your network. Routing between the VLANS will be supported by the layer 3 switch Main. Once the EtherChannels are created, the root bridge for VLAN 10 will be changed to Main. Instructions: Configure IP addressing for all end devices and access layer switches (West and South) according to the Addressing Table above. VLAN ID Name Assigned Ports 10 Students Fa0/1 - Fa0/10 20 Staff Fa0/11 - Fa0/20 88 Management Configure VLANs: In all switches, create the VLANs according to the table above. In switches West and South, configure ports Fa0/1 - Fa0/20 as access ports and assign them to each VLAN according to the table above. (VLAN 88 has no ports assigned). Channel Group Ports Protocol Main: GO/1, G0/2 1 West: G0/1, G0/2 PAgP Main: Fa0/21, Fa0/22 2 LACP South: Fa0/21, Fa0/22 West: Fa0/23, Fa0/24 3 PAgP South: Fa0/23, Fa0/24 When the network is fully configured, all devices should be able to ping each other. West Main South Lab1 Office1 Lab2 Server Office2 VLAN 10 VLAN 20 VLAN 10 VLAN 20
Expert Answer:
Related Book For
Introduction To Health Care Management
ISBN: 9781284081015
3rd Edition
Authors: Sharon B. Buchbinder, Nancy H. Shanks
Posted Date:
Students also viewed these computer network questions
-
Company s annual sales are EUR 1 0 0 m . WCR is 7 2 days of sales on average and receivables 6 2 days of sales. Assuming a 4 0 % increase in sales, resulting primarily from an increase in exports, to...
-
Create the network as shown in the topology diagram Name the PKT and word file as Firstname_Lastname_Midterm Topology Diagram: ## - Last 2 digits of student ID If your last 2 digit is 00 use 25...
-
An analyst must decide between two different forecasting techniques for weekly sales of roller blades: a linear trend equation and the naive approach. The linear trend equation is F+= 123 + 1.8t, and...
-
Below are three independent and unrelated errors. a. On December 31, 2020, Wolfe-Bache Corporation failed to accrue salaries expense of $1,800. In January 2021, when it paid employees for the...
-
Rory invested a total of $7800 in shares of ABC Ltd. and XYZ Inc. One year later the investment was worth $9310, after the shares of ABC had increased in value by 15% and the shares of XYZ were up...
-
A shopping mall has set up a promotion as follows. With any mall purchase of $50 or more, the customer gets to spin the wheel shown here. If a number 1 comes up, the customer wins $10. If the number...
-
What is the managers role in relation to strategic managerial accounting?
-
Results on seatbelt usage from the 2003 Youth Risk Behavior Survey were published in a USA Today Snapshot on January 13, 2005. The following table outlines the results from the high school students...
-
Find the average value of the function on the given interval. f(x)=ex/8; [2,7] The average value is (Round to three decimal places as needed.)
-
1. Recallthat in question one of the assignment from the last tutorial, we standardized all the values for X (hours spent playing outside with friends) and Y (hours spent playing video games along)...
-
Briefly discuss the strength and limitations of behaviorism in explaining human behavior. When memorizing a list of words, you are most likely to demonstrate if you are tested on the list...
-
2. Consider the following economy: C = 50+.75(YT) T = 40 G = 50 I = 200 - 10r r = 10 X=0 IM = 0 C+I+G+(X-IM) = Y Where C = consumption T = taxes Y = income (GDP) G = government spending I =...
-
Your mission is to track incoming meteors to predict whether or not they will strike Earth. Since Earth has a circular cross section, you decide to set up a coordinate system with its origin at...
-
Imagine a person has projection bias. For every domain she has the same alpha = .75 and therefore estimates her future utility to be: U*(c, s|s*) = (1 - alpha)*u(c; s) + alpha*u(c, s*) where s is the...
-
In an electrical experiment, the current through a resistor was set at (2.5 0.1) mA and the voltage across the resistor was found to be (5.5 0.3) V. Calculate the resistance of the resistor using R-...
-
Cash and Stock Dividends Mandrich Corporation has 50,000 shares of $10 par value common stock outstanding. The company has $303,750 of retained earnings. At year-end, the company declares a cash...
-
Find the center of mass of a thin triangular plate bounded by the y-axis and the lines y = x and y = 2 - x if (x, y) = 6x + 3y + 3.
-
Lockwood Company has two production departments, Fabricating and Assembling. At a department managers' meeting, the controller uses flexible budget graphs to explain total budgeted costs. Separate...
-
Loeb's Company's organization chart includes the president; the vice president of production; three assembly plants Dallas, Atlanta, and Tucson; and two departments within each plant Machining and...
-
The Hack craft Division of Nunez Company reported the following data for the current year. Top management is unhappy with the investment center's return on investment (ROI). It asks the manager of...
Study smarter with the SolutionInn App