Question: Determine the horizontal deflection at joint ' C ' for the truss shown in the fig . Cross sectional area of all the members is

Determine the horizontal deflection at joint 'C' for the truss shown in the fig . Cross sectional area of all the members is 600mm2 and E=200kNmm2
Determine the horizontal deflection at joint ' C

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Civil Engineering Questions!

Q:

(a) State and proof the Castigliano's theorem. (b) Using Castigliano's second theorem, determine the vertical deflection at joint F of the truss shown in Fig 3. Members have the same cross-sectional...

Q:

All ten elements of the truss shown have the same cross sectional area, A-3 in, and modulus of elasticity, E-30,000 ksi. Use the units of kips and inches to solve all parts of the problem. 1. Draw a...

Q:

Draw the shear and moment diagram for the uniformly loaded beam. Sketch the deflected shape and find the inflection point. Consider C is pin and B is a roller support. A w = 6 kips/ft A A + y Problem...

Q:

Mechanical Engineering 3. A single redundant truss structure shown as Figure 3. The truss undergoes a temperature change AT for all members. Each member has the same coefficient of the thermal...

Q:

Member 2 of the truss shown in Figure Q5 is subjected to an increase in temperature of 30C. Determine the force in member 2. Take a = 12 x 106 /C, E = 200 GPa. Each member has a cross- sectional area...

Q:

Consider a plane truss in figure 1.31. The horizontal and vertical members have length \(l\), while inclined members have length \(\sqrt{2} l\). Assume Young's modulus \(E=100 \mathrm{GPa}\), cross...

Q:

Computer analysis of a truss. The purpose of this study is to show that the magnitude of the joint displacements as well as the magnitude of the forces in members may control the proportions of...

Q:

MATLAB CODE I need help understanding what (x) is in the question. I don't know how to relate x to the number of nodes N Consider the cantilever 1 beam shown in Fig. 1: Figure 1: Schematic of a...

Q:

The load capacity of the historical Pratt truss shown in the photo is to be investigated when the load on the bottom girder AB is 600 lb/ft. A drawing of the bridge shows the centerline dimensions of...

Q:

Use method of joints to write symbolically the matrix system of equations you would use to solve for all the unknown bar forces and reactions under any loading condition for the truss in Figure Part...

Q:

What is the orbital angular momentum of an electron in the orbital? (a) 4d, (b) 2p, (c) 3p? Give the numbers of angular and radial nodes in each case.

Q:

The new little known firm is analyzed from the prospect of investments in its shares by two friends. The firm paid dividends last year 3 EURO per share. Tomas and Arnas examined the prices of similar...

Q:

2. Either the ancient Etruscans were experienced city planners and they invented the art of writing or they were highly skilled engineers and they invented the art of writing. If the ancient...

Q:

2.5pts A company that uses job order costing reports the following information for March. Overhead is applied at the rate of 60% of direct materials cost. The company has no beginning Work in Process...