Develop Electrical Control Circuit

Power and control circuit to be drawn below

$-$ The three$-$phase motor is to be started DOL using contactor K$1.$

$-$ Control is to be via pushbuttons "Local Stop", "Local Start", "Remote Stop" and "Remote Start".

$-$ A heater controlled by contactor K$2($power circuit not shown$)$ will not energise until $5$ seconds after the pump starts running and will be continuously controlled via thermostat TS$1.$

$-$ Indication lamps are to be provided to show the following...

$-$ Lamp L$1($Green$)-$ pump running

$-$ Lamp L$2($Amber$)-$ pump stopped

$-$ Overload protection is to be provided via thermal overload relay TOL.

Include all wire numbering