Draw a ladder diagram A simple read $($Load$)$ and repeat program is shown below;

The program below is auto read for $40$ Seconds, $.$ and then auto repeat after $40$ Secs.

You will write a program that Loads speed information $($in FWD direction$)$ entered by the operator, when Load Switch is $"$ON$"$ and repeat Switch is "OFF". In this mode drive will run as per Potentiometer setting set by the operator $($Changing$).$

When Load Switch is "OFF" and Run switch is "OFF" motor is stationary.

When Load switch is "OFF" and run switch is $"$ON$"$ motor will run as per loaded file $"$B$3$:$0"$

By SQL In Forward and reverse directions until Repeat switch is switched "OFF".