Draw the front view showing diameters Configure and appropriately scale an ANSI C size layout The BC
No answer yet for this question.
Ask a Tutor
Question:
- Draw the front view showing diameters
- Configure and appropriately scale an ANSI C size layout
- The BC used to locate thru holes must be on the CENTER layer
- State thickness in the title block material or in a note with heat treat spec.
- Thickness .750
Part Name/Title: Spacer
Sheet: 4 of 4
Material: 6061 Aluminum
Finish: 32 micro finish
Notes: 750 thick, Remove all sharp edges and burrs, Heat treat per MIL-H-6875 to H1100 condition
Related Book For
Posted Date: