Question: Exercise 9 . 3 For the power system shown in Figure 9 . 5 2 determine the reach in secondary ohms for zone 3 of

Exercise 9.3
For the power system shown in Figure 9.52 determine the reach in secondary ohms for zone 3 of the distance relay installed in the A substation, on the line which goes to O substation.
Figure 9.52 Power system for Exercise 9.3
Figure 9.53 Fault current contribution for Exercise 9.3
Exercise 9 . 3 For the power system shown in

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

Hello, you already did chapter 1 and 2 of my MASTERS Thesis already for me. (See attached) So normally you know masters thesis consist of 5 chapters right ??..... But in this case my thesis will be 4...

Q:

please solve asap. this question is power system protection related. thanks. The system shown in Fig 23 of a transmission system and the positive and zero sequence impedances for the various elements...

Q:

Please write a summary for article above for around 1 and a half page. Thank you! 9 A Smarter Grid Operation New Energy Management Systems in China THE POWER GRID IN CHINA HAS BEEN DEVELOP- be...

Q:

Week 3: No Plagiarism No content from other students papers. Post should be in APA 6th edition format, I will need References and in-text citations. This website should be useful for all APA...

Q:

The sensitivity of a relay refers to the smallest value of the actuating quantity at which the relay operates detecting any abnormal condition. In case of an over current relay, mathematically this...

Q:

In case of an over current relay, mathematically this can be defined as the ratio between the short circuit fault current (Is) and The relay operating current (Io). The value of Io should not be too...

Q:

Managing Scope Changes Case Study Scope changes on a project can occur regardless of how well the project is planned or executed. Scope changes can be the result of something that was omitted during...

Q:

The relay operating current (Io). The value of Io should not be too small or large so that the relay is either too sensitive or slow in responding. Damage to the equipment due to abnormally large and...

Q:

The value of Io should not be too small or large so that the relay is either too sensitive or slow in responding. Damage to the equipment due to abnormally large and unbalanced currents and low...

Q:

capital investment involved in power system for the generation, transmission and distribution is so great that the proper precautions must be taken to ensure that the equipment not only operates as...

Q:

Consider the reaction between 50.0 mL of liquid methanol (CH 3 OH; density = 0.850 g/ mL) and 22.8 L of O 2 at 27 o C and a pressure of 2.00 atm. The products of the reaction are CO 2 (g) and H 2...

Q:

A discussion of goals is usually the first portion of the rationale essay, so readers can get a sense of why you're pursuing your degree, how you want to use your degree, and what you hope to...

Q:

QUESTION FIVE [ 2 0 ] 5 . 1 Quality assurance addresses the programme, while quality control addresses the outcomes ( Rose , 2 0 0 5 ) . With reference to this, elaborate on the distinction between...

Q:

Exercise 5-3 (Algo) Present value; single amounts [LO5-3] Determine the present value of the following single amounts (FV of $1, PV of $1, FVA of $1, PVA of $1, FVAD of $1 and PVAD of $1) (Use...