Exercise 9-41 (Algo) Activity-Based versus Traditional Costing (LO 9-4, 5, 6) Asbury Coffee Enterpises (ACE) manufactures two models of coffee gainders Personal and Commercial. The Personal grinders have a snaller capacity and are less durable than the Commercial grinders. ACE only recently began producing the Cornercial model Since the introduction of the new product, profits have been steadly declining, although sales have been increasing The management at ACE belleves that the problem might be in how the accounting system allocates costs to products The current system at ACE allocates manufacturing ovechead to products based on direct labor costs for the most recent year, which is representative, manufacturing overhead totaled $2,158,500 based on production of 30,000 Personal grinders and 10,000 Commerclal grinders Direct costs were as follows Management has determined that overhead costs ate caused by three cost divers. These drivers and their costs for last year are as tollows: Required: a. How much overhead will be assigned to each product if these three cost drivers are used to allocate ovethead? What is the total cost per unit produced for each product? b. How much overhead will be assigned to each product if direct labor cost is used to allocate overhead? What is the total cost per unit produced for each product? Complete this question by entering your onswers in the tabs below. How much overhead will be assigned to each product if direct isbor cost a used to allocate overhead? What is the cotal cost per unit produced for each product? Note: Round "Total cost per Unit" to 2 decimal places