Fall $2024,$ Note: please.address each part clearly if you answer in a separate sheet

Part a$)$ Fill in the blanks$/$alternative choice questions:

$1-$Stages of the design process are: $1,2-q,3q,$ and $4(4$ points$)$

$2-$Basic goals of $q,$ is to minimize product design and engineering changes. $(1$ point$)$

$3-$DFSS is $q,(2$ points$)$

$4-$Portfolio is $q,(2$ points$)$

$5-$Main projection types are $q,$ and $q,$ Orthographic projection is divided into:$1q,$ and: $q,(4$ points$)$

$6-$There are four types of surfaces as follows: $q,,$: $,,3q,q,,$ and $4-q,$

$(4$ points$)$

$7-$The following are important skills to keep in mind for sketches and drawings: $1q,,q,3,$ and $4q,(4$ points$)$

$8-$Label the following pictures as good, poor or preferred. $(4$ points$)$

$9-$Draw the best section view for the following picture and place it in the best spot as recommended:$($The material is cast$).(4$ points$)$

$10-$Label the following pictures as good or no$.(4$ points$)$

$11-$Which alternative represents the material removal by machining:$(1$ point$)$

Part b$)$ Hand sketch drawing part:

Problem$1)$ In the following pictures, try to draw the most common multiple views, i$.$e$.$ top, front, and right views for both of the below pictures: $(12$ points$)$

Front side

Front side