Figure $2$: Final Network Design with Router providing connection to four Subnets

Your task in this Assignment

I$)$ Use IP subnet $154\mathrm{.}12\mathrm{.}0\mathrm{.}0$ for the entire High$-$Tech Organization

II$)$ Decide on the subnet number based on the diagram and also decide on the Subnet Mask

III$)$ Assign IP Address and Subnet Mask to EACH Port of the router based on which subnet they belong to$.$ Make sure the ports are ON

IV$)$ Assign IP Addresses, Subnet Mask, and Default Gateway IP Address for EACH computer, server, and tablet

Note: See Special Instructions in the next pages to Configure the Router in Figure II above $($Midterm Exam$)$

Special Instructions to Configure the Router $($PT$-$ROUTER$)$

I$)$ This Network Configuration requires careful consideration of Router Selection. You are to Select PT$-$Router. Do NOT select any other Router as the Physical View will be different and will not match the following Figure.

II$)$ Ignore Router Number: Router$12($this number is automatically assigned by CPT$).$

III$)$ To Select PT$-$Router, you will first need to select Router ICON and then from the Right$-$Panel $($list of Router Symbols$)$ you select PT$-$Router which should be next to Router Numbered $1240.$

IV$)$ Drag and Drop PT$-$Router on the CPT Main Window.

V$)$ Then Click on the PT$-$ Router and Choose Physical Tab next to Config. You should see a Figure similar to the following Figure $($Exactly$).$

Note: If the following figure does NOT match yours, then you have chosen a different Router. Try again.

Normal

No Spacing

Heading $1$

kouter$1<$

Paragraph

$\sqrt[\phantom{2}]{y}$

Styles

$\sqrt[\phantom{2}]{8}$

Physical Config CU Attributes

Top

Next, you will need to do some Hardware Configuration of the PT$-$Router.

I$)$ PT$-$Router ONLY has TWO Copper Cable Ports. You will need to ADD TWO MORE Copper Cable Ports $($NICs$)$ to the Router. You go to Physical View and Turn OFF the Router $($see ON$-$OFF Button pointed in the Figure above$).$

a$.$ There is a Switch $($ON$-$OFF$)$ on Physical View $($Scroll to the Right and you will see$).$ Click on the Switch and it will turn off the Router.

II$)$ On the left Panel $($Physical View$),$ you will see several Network Interface Card Modules. Choose the ONE that says Copper Media or Copper or Fiber Media $($CFE$).$ Read the description to make sure it is Ethernet and

States$)$ L$1-$Public

Text Predictions: On

if$.$ Accessibility: Investigate

Search

notTan

IV$)$ Now TURN ON your Router. DO NOT FORGET THIS STEP $($YOU SHOULD SEE SAMLL GREEN LIGHT ON THE SWITCH$)$

V$)$ After Step $($IV$)$ above you should have FOUR Ports that support Copper Cables on your Router.

VI$)$ NOW connect each Router Port to Layer $2$ Switch as required in your Assignment. Choose Auto Connect FOR CABLES

NOW YOU ARE READY TO USE THIS PHYSICALLY CONFIGURED ROUTER TO COMPLETE YOUR NETWORK DESIGN AS PER FIGURE II ON PAGE $2($Midterm Exam Network Diagram$).$

REQUIREMENTS AND DELIVERABLES FOR MIDTERM EXAM PART II USING CPT $($NON$-$NEGOTIABLE$)$:

a$.$ Ping Server $0$ from $PC0$

b$.$ Ping Server $1$ from PC$1$

c$.$ Ping Server $0$ from Tablet $3$

d$.$ Ping Server $1$ from Tablet$0$

Figure l: Original Network Diagram from Assignment I