Question: For a given process, the upper specification and lower specification limits are set at 2.549 and 2.503 respectively. If the standard deviation for this process

For a given process, the upper specification and

For a given process, the upper specification and lower specification limits are set at 2.549 and 2.503 respectively. If the standard deviation for this process is 0.0036 and the mean is 2.530, calculate the following indices. (i) Process capability index Cp. (ii) Process capability index Cpk. Using your results, make recommendations as to whether this process is capable, and likely to meet its specification requirements. What are the relative advantages of the two types of process capability index

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related General Management Questions!

Q:

1 . Describe how to assess the capability of any process to meet its requirements and stay within predefined specification limits . State the different choices of control chart available and the...

Q:

1 . Describe how to assess the capability of any process to meet its requirements and stay within predefined specification limits . State the different choices of control chart available and the...

Q:

1 . Describe how to assess the capability of any process to meet its requirements and stay within predefined specification limits . State the different choices of control chart available and the...

Q:

1 . Describe how to assess the capability of any process to meet its requirements and stay within predefined specification limits . State the different choices of control chart available and the...

Q:

STATS 136-B NEED THIS ASAP. 5MINS! READ COMMENTS FOR INSTRUCTIONS! PLEASE SKIP IF YOU CANT FINISH! I WILL REPORT THOSE WHO WILL FLAG THIS. THANKS 10. If Cp>Cpkwhat conclusion can be carried out about...

Q:

From a Statistical Process Control analysis, the Mean Chart shown below was retrieved. What is the maximum value that Point 2 (shown on the chart within a circular marker with red border) may take,...

Q:

Question 13 (6 points) A company is manufacturing pipes. To check whether their production is "in-control", they decided to develop a Mean Chart with regards to the outer diameter of the manufactured...

Q:

2. Given a mean and target of 20, an upper specification limit of 28, a lower specification limit of 12, and a standard deviation of 5, calculate the Cpk. What does this information tell you about...

Q:

What are the Statistics Mentioned? Sample Size (n): Number of Groups: Number of Treatments: Standard Deviation (): Standard Error: Mean (): F Statistic: Degrees of Freedom (df): P-Value: An ANOVA...

Q:

What are the Statistics Mentioned? Sample Size (n): Number of Groups: Number of Treatments: Standard Deviation (): Standard Error: Mean (): F Statistic: Degrees of Freedom (df): P-Value: An ANOVA...

Q:

Draw a labeled diagram of human digestive system and describe the process of digestion of food in human. OR What happens to the food once it enters our body?

Q:

The length of components produced by a company is normally distributed with a mean of 6 cm and a standard deviation of 0.02 cm. Calculate the 1st, 2nd, and 3rd quartiles of the component length.

Q:

One factor that may dictate a surplus lines insurer's classes of business is the Select one: A . Level of accounting expertise available to the insurer. B . Individual and business tax rate in the...

Q:

Scenario: Officer Johnson responds to a domestic violence call and arrives at a scene where a highly agitated individual, Mark, is arguing with his partner. Mark's behavior escalates, and he becomes...