For Project $2,$ in rust you$$ll be given a file that needs to be parsed and actuated. The file consists of two types of commands: linear motion and rotational motion. For the linear motion commands, you must output the positions you$$re moving to in one$-$unit increments. For example, if you$$re moving from $0,0,0$ to $0,5,1,$ the following positions should be reported $($always to two decimal positions$)$:

$1.0,0\mathrm{.}98,0\mathrm{.}2$

$2.0,1\mathrm{.}96,0\mathrm{.}39$

$3.0,2\mathrm{.}94,0\mathrm{.}59$

$4.0,3\mathrm{.}92,0\mathrm{.}78$

$5.0,4\mathrm{.}90,0\mathrm{.}98$

$6.0,5,1$

In the case on rotational motion, You$$ll be given a position of a circle, its radius, and a direction $($clockwise or counterclockwise$),$ and a stop location. From this, you$$ll need to output position at $5-$degree intervals, visualized below:

Application Fineatures

The features must be enabled in your application:

$$ File reading

$$ Text parsing

$$ Linear motion calculations

$$ Rotational motion calculationsIn the case on rotational motion, You'll be given a position of a circle, its radius, and a direction

$($clockwise or counterclockwise$),$ and a stop location. From this, you'll need to output position at $5-$

degree intervals, visualized below:

Application Features

The features must be enabled in your application:

File reading

Text parsing

Linear motion calculations

Rotational motion calculations