Question: Figure 1, shows an RC continuous beam supporting various loads and actions. The loading condition and dimension data are given in Figure 1 and
Figure 1, shows an RC continuous beam supporting various loads and actions. The loading condition and dimension data are given in Figure 1 and as a function of UC (uniqueness code). Your Uniqueness Code (UC) is made up from the SUM of the second and last numbers of your URN number and calculated as follows below. (Please make sure that you include this information in your coursework submission): Second number of your URN. 7 Last number of your URN. 9 Your Uniqueness Code (UC) = 16 For example, for Mr Fred Smith with his student ID number of 1078128, because the 2nd number of his ID is 0 and the last is 8, his UC number = 0 + 8 = 8. A w=7UC(kN/m) 2.0EI 9.0m XB 2.0m P=10UC (KN) 4.0EI 3.0m D co www W=15UC (kN/m) 4.5EI 8.0m www num Please clearly state the input parameters and assumptions made at the start of your numerical modelling.
Step by Step Solution
3.52 Rating (165 Votes )
There are 3 Steps involved in it
a continuous reinforced concrete RC beam with various loads and acting on it The beam is supported at points A B C and D The following input parameters and assumptions are made at the start of the num... View full answer
Get step-by-step solutions from verified subject matter experts
