Question: For the extruded beam, the cross - section is shown in Fig . 4 . Determine ( a ) location of the shear centre O

For the extruded beam, the cross-section is shown in Fig.4. Determine (a) location of the shear centre O(b) the distribution of the shearing stresses caused by the vertical shearing force, F =35 kN applied at O. Given Iz =0.933 x 106 mm4. solve in detail
For the extruded beam, the cross - section is

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Mechanical Engineering Questions!

Q:

QUESTION 4 As a product development Engineer at a local company, you have been asked to design a new thin-walled open section to be used as a column in residential construction. After numerous trials...

Q:

The beam has a rectangular cross section and is subjected to a load P that is just large enough to develop a fully plastic moment M p = PL at the fixed support. If the material is elastic perfectly...

Q:

1 4 - 2 9 An overhanging beam having a T - section in . ( } is subjected to the concentrated load shown in Fig. P 1 4 - 2 9 . Determine the shear stresses in sectionat the levels indicated. Show the...

Q:

Strength of Materials HIA ARAMATA UNIVER 14. An extruded aluminum beam has the cross section shown. Knowing that the vertical shear in the beam is 150 kN, determine the shearing stress at: (a) point...

Q:

4. Consider the rectangular beam in Fig. 1. We wish to confirm the relation between the shear force in the beam and shear stresses that may exist in the beam. We will work within the general...

Q:

The beam AB shown below in Figure 3 has the cross section as shown. The beam has been fabricated by welding a 150 x 50 x 5.0 RHS (Rectangular Hollow Section) to two sections of flat plate; 150 mm x...

Q:

The subject of the project is an overhang beam presented in Fig. 1a. The beam is hinged supported at point a and supported by the bar at point c. The cross section is presented in Fig. 1b. The load...

Q:

Consider a 400mm long beam with a pinned left and simple roller right supports at each end respectively The beam is subjected to three concentrated forces P P and 3P as shown in the figure below The...

Q:

A simple wing section is completely idealised as shown below. The section consists of two flat spar webs and two curved skin panels. It is symmetric about a mid-plane running through the centre of...

Q:

A cross - section of a beam is shown in Figure Q 2 . If the shear force in this section is V = 1 5 9 K N , determine the value and the location of the maximum shear stress in the section. In Figure Q...

Q:

Sweet Enterprises Ltd., a private company following ASPE earned accounting income before taxes of $1,721,000 for the year ended December 31, 2020. During 2020, Sweet paid $230,000 for meals and...

Q:

Nine 10-? resistors are connected as shown in Figure, and a potential difference of 20 V is applied between points a and b. (a) What is the equivalent resistance of this network? (b) Find the current...

Q:

Exam One ( 1 ) Help Soue 8 Lokesh was thrilled when she found a low - cost airfare to Park, but she was not happy when she bought the tickets and realtzed there were hundreds of dollars i 2 2 added...

Q:

Required Information C4-2 (Algo) From Recording Transactions (Including Adjusting Journal Entries) to Preparing Financial Statements and Closing Journal Entries (Chapters 2, 3, and 4) [LO 2-3, LO...