For this learning task, you will use the PhET DC circuit construction kit to simulate some series circuits as well as analyze series circuits using Kirchhoffs laws and Ohms Law. Use the GRASP method to communicate your calculations and be sure to state your final answers using the correct number of significant digits.Complete the following tasks:Create the following circuit using the simulator. Use an ammeter to measure and record the current flow through the battery and each light bulb. Use a voltmeter to measure and record voltage across the battery and each light bulb. This image depicts a circuit created using the PhET DC circuit construction kit incorporating a battery and two light bulbs connected in series.by PHET $-$ University of ColoradoComplete a calculation to verify KVL for the circuit.Predict the current flow through the battery if a $3$rd light bulb were added to the circuit. Explain your prediction using Kirchhoffs Laws.Add a $3$rd light bulb to the circuit. Measure and record the current flow through the battery. Did your prediction match the result?Create a schematic diagram of a circuit that has a battery supplying $23$ V to three resistors $($R$\_\{1\}=15\backslash$Omega$,$ R$\_\{2\}=44\backslash$Omega and R$\_\{3\}=25\backslash$Omega$)$ connected in series.Complete an analysis, using Kirchhoffs laws and Ohms Law, to predict all V and I in the circuit.Create the circuit from the schematic diagram you created in question $5.$ Measure and record all V and I and compare to your calculated values.Complete a calculation to determine the equivalent series resistance that could replace the resistors in the schematic diagram you created in question $5.$