Question: Given a balanced assembly line. If the fastest operation has a standard time of 0.421, and the third operation has a standard time of 1.431,

Given a balanced assembly line. If the fastest operation has a standard time of 0.421, and the third operation has a standard time of 1.431, use this information for this question and the following points.

E. Calculate the pieces per hour if done in batch.

F. Calculate the hours per thousand in batch.

G. Calculate the pieces per hour in line mode.

I. Calculate the hours per thousand in line mode.

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related General Management Questions!

A single model assembly line in a garment industry produces a standard size XL-shirt for construction workers. The description of the work content for assembling the garment is listed in table /...

QUESTION 1 What is the time value of one TMU? One TMU equals 0 . 0 0 0 0 4 hour or 0 . 0 0 0 6 minute. One TMU equals 0 . 0 0 0 0 3 hour or 0 . 0 0 0 6 minute. One TMU equals 0 . 0 0 0 0 2 hour or 0...

What changes would you make to the company's current target costing system and strategy? Olympus Optical Company, Ltd. (A): Cost Management for Short Life-Cycle Products Introduction Olympus, which...

QUESTIONS: 1. Is there anything unusual about Olympus' product planning process? 2. Is the (life-cycle costing) LCC method properly applied in this case? THIS IS THE CASE from Harvard Business...

Olympus Optical Company, Ltd. (A): Cost Management for Short... Olympus Optical Company, Ltd. (A): Cost Management for Short Life-Cycle Products Introduction Olympus, which consisted of Olympus...

QUESTIONS: 1. How did Olympus respond to the challenges raised in the mid-1980s? What their response appropriate? 2. Why did the firm shift the responsibility of product planning from R&D to...

Hi! How would you allocate cost using cycle time in lean manufacturing? What alternatives would you suggest to allocate their conversion costs? ISSN 1940-204X Aero Gear, Inc.: Performance...

Read the text in photos and answer the following question As in most areas of life and work, advances in information technology have focused attention on the importance of good information systems to...

Analyze the American Red Crosss budgeting and financial management and its financial analysis practices. Analyze the current profit or loss and long-term fiscal strength of the nonprofit, in light of...

Blossom Inc. wishes to accumulate $1,508,000 by December 31, 2030, to retire bonds outstanding. The company deposits $232,000 on December 31, 2020, which will earn interest at 12% compounded...

Which of the following are fiduciary type funds? Select one: a . Custodial Fund, Internal Service Fund, and Pension Trust Fund b . Investment Trust Fund, Special Revenue Fund, and Internal Service...

Myers Company uses a flexible budget for manufacturing overhead based on direct labor hours. Variable manufacturing overhead costs per direct labor hour are as follows. Fixed overhead costs per month...