Here is the show ip route command from router R$1,$ which is load$-$balancing to the $10\mathrm{.}80\mathrm{.}13\mathrm{.}0/30$ network.

R$1>$ show ip route

Codes: C $-$ connected, S $-$ static, R $-$ RIP, M $-$ mobile, B $-$ BGP

D $-$ EIGRP, EX $-$ EIGRP external, O $-$ OSPF, IA $-$ OSPF inter area

N$1-$ OSPF NSSA external type $1,$ N$2-$ OSPF NSSA external type $2$

E$1-$ OSPF external type $1,$ E$2-$ OSPF external type $2$

$*-$ candidate default, U $-$ per$-$user static route

o $-$ ODR, P $-$ periodic downloaded static route

Gateway of last resort is not set

$10\mathrm{.}80\mathrm{.}0\mathrm{.}0/8$ is variably subnetted, $11$ subnets, $4$ masks

D $10\mathrm{.}80\mathrm{.}13\mathrm{.}0/30[90/2681856]$ via $10\mathrm{.}80\mathrm{.}234\mathrm{.}3,01$:$13$:$17,$ Serial$0/0$

$[90/2681856]$ via $10\mathrm{.}80\mathrm{.}234\mathrm{.}2,01$:$13$:$17,$ Serial$1/0$

D $10\mathrm{.}80\mathrm{.}23\mathrm{.}2/32[90/2681856]$ via $10\mathrm{.}80\mathrm{.}234\mathrm{.}2,01$:$13$:$17,$ Serial$0/0$

On R$1,$ the following change was made. In which two ways will the EIGRP routing table and topology table be affected? $($Choose two.$)$

R$1($config$)$# router eigrp $10$

R$1($config$-$router$)$# maximum$-$paths $1$

There will be no change in the routing table for the route $10\mathrm{.}80\mathrm{.}13\mathrm{.}0/30.$

The EIGRP topology table will indicate both routes to the network $10\mathrm{.}80\mathrm{.}13\mathrm{.}0/30.$

The EIGRP routing table will have only one route for $10\mathrm{.}80\mathrm{.}13\mathrm{.}0/30.$

The EIGRP topology table will have only one route for $10\mathrm{.}80\mathrm{.}13\mathrm{.}0/30.$

The EIGRP topology table will have no route for $10\mathrm{.}80\mathrm{.}13\mathrm{.}0/30.$