******i need the answer for all, i will upvote for sure

1) When constructing the IMR control charts, what can the lowest value of MR be? e) 1 f) -2 g) 0 h) -1 2) The actual process capability takes into consideration both the variability and the mean of the process? True or false without explanation. 3) In variable control charts, continuous data is being used. True or false without explanation. 4) If the sample size n is not large enough say, n10 then X bar and R control charts are preferable to use. True or false without explanation. 7) if the LSL of the quality characteristic increases, the process capability ration CP will e) Decrease f) will remain same g) Increase h) Can't say(can increase as well as decrease) 8) The moving range may be negative. True of false 9) Which of these should be plotted on the X-bar chart? None of them Counts Defects Measurement 10) The LSL in the CP is called: e) Lower specification limit f) Largest safe limit g) Largest specification limit h) Lower safe limit In a chemical plant involved in making- paint for household use, the viscosity of the paint must be maintained. The following is a summary of the data for 15 viscosity values. The mean viscosity rate X= 197 and the mean of the moving ranges MR = 5. Please answer the below questions by entering the results into the boxes next to each question. In the answer box below just write the number (No Units, no words). a-) (4 points) What is the UCL for the Individual Control chart? b-) [2 points) What is the centerline for the Individual Control chart? c-) (4 points) What is the LCL for the Individual Control chart? d-) [4 points] What is the UCL for the range control chart2 d-) (4 points) What is the UCL for the range control chart? e-) (2 points] What is the centerline for the range control chart? f-) [4 points) What is the LCL for the range control chart