What preload torque should be applied to an M14x2, ISO class 8.8 bolt to get a...
Fantastic news! We've Found the answer you've been seeking!
Question:
Transcribed Image Text:
What preload torque should be applied to an M14x2, ISO class 8.8 bolt to get a 51.75 kN preload? At this pre-load, what is the factor of safety with respect to yielding the bolt in tension? What is the stiffness of the bolt if it is 60 mm long and used in a joint where the grip length is 45 mm? What preload torque should be applied to an M14x2, ISO class 8.8 bolt to get a 51.75 kN preload? At this pre-load, what is the factor of safety with respect to yielding the bolt in tension? What is the stiffness of the bolt if it is 60 mm long and used in a joint where the grip length is 45 mm?
Expert Answer:
Answer rating: 100% (QA)
To determine the preload torque required for the M14x2 ISO class 88 bolt we can use the following fo... View the full answer
Related Book For
Intermediate Accounting Volume 2
ISBN: 9781119497042
12th Canadian Edition
Authors: Donald E. Kieso, Jerry J. Weygandt, Terry D. Warfield, Irene M. Wiecek, Bruce J. McConomy
Posted Date:
Students also viewed these accounting questions
-
A steel cable with nominal diameter 25 mm (see Table 2-1) is used in a construction yard to lift a bridge section weighing 38 kN, as shown in the figure. The cable has an effective modulus of...
-
Jones Oil Co. acquired Oil Rights for $3,000,000. It was estimated that the well would produce 1,500,000 barrels. During the 20Y9, 40,000 barrels was collected and sold. 1. Determine the depletion...
-
A pinned-end column with length L = 18 ft is constructed from a W 12 ( 87 wide-flange shape (see figure). The column is subjected to centrally applied load P1 = 180 k and an eccentrically applied...
-
Muskoka Boys Shaving Co. (MBSC") is a GST/HST registrant operating an online store in Ontario's cottage country region. The company specializes in selling fine grooming products for men. It is June...
-
Sources and Uses of Cash For each account on this companys balance sheet show the change in the account during 2007 and note whether this change was a source or use of cash. Do your numbers add up...
-
In Exercises, approximate the area under the graph of f(x) and above the x-axis using the following methods with n = 4. (a) Use left endpoints. (b) Use right endpoints. (c) Average the answers in...
-
Charting, Inc., a new audit client of yours, processes its sales and cash receipts documents in the following manner: 1. Payment on account. The mail is opened each morning by a mail clerk in the...
-
Page 205 shows a work sheet for Megaffin's Repairs. No additional investments were made by the owner during the month. REQUIRED 1. Prepare an income statement. 2. Prepare a statement of owner's...
-
Select two of the Morality Crimes below (you may go off of this list if you seek approval from your instructor). Define the criminal action in general terms or find that actual federal or state law...
-
Consider the process model in Fig. 7.14. This model captures a simplified process for handling applications for mortgages. There are two checks involved. CT1 deals with a check of the financial...
-
Benefits of the electronic exchange in the economy of Dubai Mercantile exchange (DME).
-
What two key values are identified for each performance parameter in the Capability Development Document (CDD) to bind the design of the system, yet provide the Program Manager with flexibility to...
-
A car generator turns at 590 rpm when the engine is idling. Its 370-turn, 7.20 by 9.20 cm rectangular coil rotates in an adjustable magnetic field so that it can produce sufficient voltage even at...
-
a. A nonferrous screwdriver is being used in a 1.90 T magnetic field. What maximum emf can be induced along its 13.5 cm length when it moves at 4.90 m/s? b. Is it likely that this emf will have any...
-
a. An MRI technician moves his hand from a region of very low magnetic field strength into an MRI scanner's 2.10 T field with his fingers pointing in the direction of the field. Find the average emf...
-
a. An MRI technician moves his hand from a region of very low magnetic field strength into an MRI scanner's 2.30 T field with his fingers pointing opposite to the direction of the field. What current...
-
What is the Inventory Turnover? 2. What is the AR Turnover? 3. What is the AP Turnover? 4. What is the Inventory Period? 5. What is the AR Period? 6. How long is the Operating Cycle? 7. How long is...
-
Propose a reasonable mechanism for the following reaction. OH
-
Use the information for Sorpon Corporation in E18.12. Assume that the company reports accounting income of $180,000 in each of 2021 and 2022, and that there are no reversing differences other than...
-
Standard Corp's net income for 2020 is $150,000. The only potentially dilutive securities outstanding were 1,000 call options issued during 2019, with each option being exercisable for one share at...
-
Shaddick Corp., a public company following IFRS, began its 2020 fiscal year with a debit balance of $11,250 in its Income Tax Receivable account. During the year, Shaddick made quarterly income tax...
-
Form small groups of four to five individuals. Using the worksheet Be the Best We Can Be Team Norms, discuss how the answers to the questions can assist the group with developing team norms so that...
-
Explain why teams and groups are not the same.
-
List the teams of which you are a member. Select one of these teams to analyze. Is it a high performing team? If so, why is it? If not, why isnt it? What changes need to be made to increase the the...
Study smarter with the SolutionInn App