Question: If the DC base - emitter junction voltage, Vbe, for an NPN BJT in the forward - active region is equal to 6 6 6

If the DC base-emitter junction voltage, Vbe, for an NPN BJT in the forward-active region is equal to 666 mV then what is the collector current flowing in this BJT, Ic, in milliamps? Assume that the saturation current for this BJT, Is, is equal to 43 fA.(Note that 1 fA =1 femtoamp =1 x 10^-15 A.) Neglect the effects of base-width modulation. Also assume that the thermal voltage is equal to Vt = kt/q =26mV. Since Ic is very sensitive to small changes in Vbe, be sure to use Vbe to the nearest millivolt when calculating your answer!

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

In all cases, a thermal equilibrium state or a steady state is assumed, depending on the application of voltage. Abrupt junction assumption, Application of Depletion Approximation In the NPN BJT of...

Q:

A base-emitter voltage of 480 mV is measured on a super- test transistor with a 100 m 100 m emitter area at a collector current of 10 A. Calculate the Q B and the sheet resistance of the base...

Q:

a) "What is a Bipolar junction transistor (2mks) b) Briefly describe the operation of N-P-N transistor (6mks) c) Consider a BJT with emitter doping of 108 cm and base doping of 10 cm. The quasi-...

Q:

A silicon n+pn BJT has the following parameters: emitter, base, and collector doping concentrations are 2 x 10^18 cm-3, 10^16 cm-3, and 10^15 cm-3. Assume the corresponding lifetimes are 10^-8,...

Q:

Problem 1. Nonideal effects There are two npn bipolar transistors that are same except the emitter and collector region doping are interchanged. Device A: NE=107 cm, NB = 105 cm, Nc = 1014 cm Device...

Q:

The 2N3904 NPN BJT Is Specified To Have Isc = 6.7 FA And HfE = B = 200. A Base To Emitter Voltage Of VBE = 0.7 V Is Applied To A 2N3904 Transistor. Calculate Its Collector, Base And Emitter Currents,...

Q:

Describe the motion of electrons and holes in a p-n-p bipolar transistor biased in the forward active mode with VBC = 0. How will it change if reverse bias is applied to the B-C junction? How much...

Q:

Production Costs Cost Object No.1 Cost Object No.2 Cost Object No.3 DMC $6000 4000 10000 DLC $8000 5000 No. of MH 500 900 600 Total indirect costs for the year for producing the three cost objects...

Q:

The dc base voltages in Figure 1837 are zero. Using your knowledge of transistor analysis, determine the dc differential output voltage. Assume that Q 1 has an = 0.98 and Q 2 has an = 0.975. FIGURE...

Q:

Again consider the circuit shown in Figure 10.37(a). Let \(V^{+}=5 \mathrm{~V}\) and \(R_{1}=35 \mathrm{k} \Omega\). Let \(V_{E B 1}\) (on) \(=0.6 \mathrm{~V}\). Neglect dc base currents. The...

Q:

Calculate Basic and Diluted earning per share with the following data.(20) - Share capital on 01-04-2021 5,00000 equity shares of Rs. 10 each. -Issue of right shares at par for cash on 01-07-2021 in...

Q:

A Brayton cycle inlet is at 300 K, 100 kPa and the combustion adds 670kJ/kg. The maximum temperature is 1200 K due to material considerations. What is the maximum allowed compression ratio? For this...

Q:

true or false: A significant deficiency in internal controls is defined as a deficiency, or a combination of deficiencies, that result in a reasonable possibility that a material misstatement would...

Q:

Why companies can and must have both data utility and privacy With marketers and publishers prioritising addressability, data collaboration between the two takes on a new importance. Leveraging data...