If you can solve the full answer properly, then give the solution, otherwise, skip. Else, you will be reported instead of a thumbs-up. Thank you in advance! Course name: MICROPROCESSOR AND EMBEDDED SYSTEMS Question: On new year's eve, the Hatirgheel authority is planning to shoot high powered high frequency laser light waves as pulses into space for research purposes. These pulses are to be shot at a 3 interval. The authority has an ATMega328P MCU available and decided to use it to count the time. Every 3 s a timer interrupt will be triggered by the MCU and the pulse will be shot. For this purpose, considering the power consumption and necessity, it has been decided that the Timer0 interrupt will be used. If the MCU is running at 16MHz, prepare a program that triggers Timer0 interrupt every 3s. Timer0 is an 8-bit timer, and the available pre-scalers are 1,8,64,25, and 1024 . [Hint: Bits 0 to 2 of the TCCR0B register must be set. These bits correspond to the pre-scaler to be used. The pre-scaler selection bits are shown in the table below. Output Compare Register 0A: OCR0A holds the necessary Timer0 count to achieve the required delay. Bit 1 from TIMSK 0 is OCIE 0A - this bit must be set to enable comparison match A. Any bits not mentioned here are to be considered as 0 . All registers mentioned are 8 -bit registers.]