Question: If you have a 1 inch diameter fitting or pipe, you should drill a hole that is _ _ _ _ _ _ _ _

If you have a 1 inch diameter fitting or pipe, you should drill a hole that is __________ then 1 inch?
Group of answer choices
Smaller
Larger
Exactly 1 inch

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Mechanical Engineering Questions!

Q:

If a 1/2 inch diameter twist drill is used to drill a hole in copper, the spindle speed is 140,000 rpm (rpm should be an integer). If the tool feed is 0.005 ipr, the feed rate is _________ ipm (keep...

Q:

If a 1/2 inch diameter twist drill is used to drill a hole in copper, the spindle speed is ________ rpm (rpm should be an integer). If the tool feed is 0.005 ipr, the feed rate is _________ ipm (keep...

Q:

subject:MECHANICAL AND ELECTRICAL SYSTEMS QUESTION 3 a) Water pressure is a crucial measure of water supply system in a building. Pressure loss due to elevation and friction from pipes and fittings...

Q:

Estimate the time required for a single cut in each of the following machine operations: a. Turn 1 inch diameter x 6 inch long. V= 100 fpm, f=0:010 inch/rev. b. Turn 0.125 inch in deep recess in a 2...

Q:

Consider an 18-inch-diameter pipe that carries propane at a pressure of 500 psia. The gas can be considered at room temperature. The pipe suffers a perforation of 1 inch diameter so it immediately...

Q:

The stanciard site for a long slotted hole for a 1 inch diameter bot is 1 1 8 - inch by 1 5 1 6 inch. The radius at all corners is 9 1 6 inch. A diagram is shown below. This hole must be made in a 5...

Q:

1) Calculate the hydraulics radius( Rh) of a flow flowing through annulus section of a circular pipe (radius =1 inch) into a square pipe (15cm per side). Express Rh in "inch". 2) Calculate the...

Q:

q24 Studies on a machine that molds plastic water pipe indicate that when it is injecting 1 -inch diameter pipe, the process standard deviation is 0.05 inches. The one-inch pipe has a specification...

Q:

A Machine that molds plastic water pipes indicates that when it is making a 1 inch diameter pipe the process standard deviation is 0.005 inches. The one-inch pipe has a specification of 1 inch plus or

Q:

Which of the following is the correct RPM for drilling a 1 inch diameter Hole having a cutting speed ( SFPM ) of 5 0 ? a ) 1 6 0 RPM b ) 2 0 0 RPM c ) 2 5 0 RPM d ) 1 7 0 RPM Cutting Fluids used in...

Q:

For each of the following, categorize the nature of the data using one of these three descriptions: (1) Discrete because the number of possible values is finite; (2) discrete because the number of...

Q:

1. What is the yield to maturity on a $10,000-face-value discount bond maturing in one year that sells for $9,523.81? 3. The primary deposit is $10 million, required reseve rate is 10%, currency...

Q:

The main advantage of REIT over direct investment in real estate is _ _ _ _ _ _ _ _ .

Q:

Under this doctrine, either party may terminate the employment relationship at any time and for any legal reason: employment at will employment contract stare employment decisis labor freedom