1. If you will be given the data below, what quality tools will you use? ( 5 pts )

On Semiconductor has an average output of the 40 lead microprocessor on the following quarters for the Trimming Operation , Q1= 10,220,000 pcs, Q2 = 1,203,900, Q3 = 1,450,000 and Q4 = 1,200,400.

They need to oversee the performance of the same operation using the standard 20mm +/- 2 mm. Rejection level during the last quarter is high and caused by workers mistake, substandard materials and poor working environment.

1. Checksheet, Scatter Diagram and Control Chart
2. Checksheet, Control Chart and Fishbone Diagram
3. Control Chart, FLowchat and Pareto Diagram
4. Flowchart, Scatter Diagram and Control Chart
5. Control Chart , Histogram and Fishbone Diagram

Referring to the figure, which statement does not interpret the diagram correctly? 5 pts) 16 14 Hours 10 4 7 10 12 IU 20 22 24 Age a a. This is a scatter diagram showing relationship between the ages and hours spent for extra curricular activities. b. The age is inversely proportional with extra curricular hours. C. This is a scatter diagram with positive correlation. d. It shows that the extra curricular hours are decreasing as people gets older e. None of the above 1. Given the entire process, what 2 recommendation from among what are given below are not going to address the problem of the company? E pts - 2.5 pts for each correct answer) Material Measurement Wrong specification of the material Wrong size of the mold poor storage conditions blueprint mistake Worn out material production mistake Machine Machine malfunction employee's fault machine defect The part is produced wrong size wrong production procedure wrong production conditions too hot too cold too humid Employee mistake mistaken machine settings mistake in production procedure Method Environment People a. Conduct strict incoming inspection b. Improve the compensation package of the employees c. Improve the storage facilities and machine conditions d. Ensure that manpower is well trained e. Mold should be checked based on blueprint f. Increase the working hours. g. Workers' training on machine setting