Question: In a system controlled by a plc , if water is pouring down from a tank on to equipment, which device should be checked in

In a system controlled by a plc, if water is pouring down from a tank on to equipment, which device should be checked in the plc device to ensure the safety of the equipment?
A) Temprature sensor
B) Flow meter
C) presure gauge
D)Level transmitter

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

1 . During operation, the reverse function of a motor fails to engage. What is the most likelycause of this issue? A ) The forward contact is closed B ) The reverse contact has failed to close C )...

Q:

In a system controlled by a PLC , if water is pouring down from a tank onto equipment, which device should be checked in the PLC setup to ensure proper protection and safety of the equipment? A )...

Q:

1 . During operation, the reverse function of a motor fails to engage. What is the most likelycause of this issue? based on canadian electrial book 2 0 1 9 A ) The forward contact is closed B ) The...

Q:

Building and Construction BSBSMB401 Establish legal and risk management requirements of small business Learner Materials and Assessment Tasks Table of Contents About BSBSMB401 Establish legal and...

Q:

FAA APARTMENT LEASE CONTRACT NAA NATIONAL APARTMENT ASSOCIATION Date of Lease Contract: (when the Lease Contract is filled out) This is a binding document. Read carefully before signing. Moving In -...

Q:

5-180 Determine the power input for a compressor that compresses helium from 150 kPa and 20C to 400 kPa and 200C. Helium enters this compressor through a 0.1-m2 pipe at a velocity of 15 m/s. 5-181...

Q:

ATTEMPT ALL QUESTIONS. BE SURE TO ANSWER A body with mass m = 1 2 kg is attached to the end of a spring that is stretched 2 m by a force of 100 N. Furthermore, there is also attached a dashpot4 that...

Q:

1 WILMINGTON UNIVERSITY LIBRARY Business Continuity Plan (BCP) and Disaster Recovery Plan (DRP) 2 WILMU LIBRARY SERVICES 20,000 student population served 13 physical locations of access to university...

Q:

16-5 figure 16-5 figure is at the top of the page and only 1 page and 16-8 figure is other pages. I. GENERAL HOUSEKEEPING Adequate and wide aislesno materials protruding Material piled in safe...

Q:

You are working for ABC Engineering and have been assigned the task to create a PLC project to control the mixing operation described below. Safety is a primary concern for the control system. The...

Q:

One of the key roles of Leaders is to have the ability to influence a group towards the achievement of a vision or set of goals. Select a leader that you are familiar with and describe their...

Q:

Explore and explain three methods of collecting primary and secondary data and determine the advantages and disadvantages of each method. Explain ethics in conducting research and how ethics is...

Q:

Discuss the various uses of financial statements for the following parties: investors, internal managers, and potential employees

Q:

draw a two-phase ATD consisting of an initial baseline phase followed by a phase in which two or more conditions (one of which may be a no-treatment control condition) are alternated for one...