Question: In MPLAB write and compile (using the simulator) an assembly language program with the following functionality: Configures pin RA2 of the PIC24to be an output
In MPLAB write and compile (using the simulator) an assembly language program with the following functionality:
Configures pin RA2 of the PIC24to be an output to control an attached LED.
Configures pin RB13 of the PIC24 to be an input to read the value on an attached switch (this switch will connect to ground when pressed).
Configures pin RB13 to use the internal pull-up resistor.
After configuration, the LED will be "off" when the push-button is pressed, and "on" when it is released.
Remember, since this is an assembly language program you cannot use the C-language macros. Also, that in an assembly language program the name of a register is a reference to its memory location.
Step by Step Solution
There are 3 Steps involved in it
Get step-by-step solutions from verified subject matter experts
